Electronics Forum | Tue Jul 30 07:32:43 EDT 2002 | bpan
I currently use the Slim Kic 2000 and really like its results. Just would like to say that I recommend the product. It works well and the software is user friendly.Profiles can be achieved quickly with great results.
Electronics Forum | Mon Jul 29 19:21:58 EDT 2002 | davef
Look to: * Your flux supplier's recommendations to baseline your recipe [similar to using your paste supplier's recommendations for setting your reflow recipe] * 7530 'Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)' for gui
Electronics Forum | Thu Aug 22 05:27:42 EDT 2002 | zolasteven
Hi, With regards to reflow oven or furnace, when conducting a temperature profile how does one determine how many points(Parts) on the pcboard to be measured/connected to the temperature profile. And how to determine what parts to measure? Than
Electronics Forum | Tue Aug 27 01:11:31 EDT 2002 | zolasteven
Hi Dave, Thanks for your input. By the way where I can find on-line reference on Review IPC-7530 (Guidelines for Profiling) Generally, what is the recommended frequency for conducting temperature profile? Thanks & rgds, Steven
Electronics Forum | Fri Oct 18 15:23:34 EDT 2002 | mmulgrew
I agree with Monkey. We are a CM and profiling is a way to CYA. If we allowed operators to make decisions on when to and when not to you could end up in a bad spot.
Electronics Forum | Fri Jan 24 09:33:36 EST 2003 | pjc
ECD has a product called the OverRIDER for benchmarking and trending oven performance. http://www.ecd.com/emfg/instruments/ovenrider/
Electronics Forum | Thu Mar 27 17:29:11 EST 2003 | paul
can any one tell me if you should run the same heat on the same boards no matter what deffrent parts are on the board Should you do a oven profile for every deffrent board or is it the thickness of the board that matters.
Electronics Forum | Sun Mar 30 20:21:44 EST 2003 | iman
we are using a "recommend supplier profile", and we have gotten back to the talking table with them over this profile specs. Thanks for the pointer, have ask them on this issue. Have also asked for their phase-transistion diagram to understand their
Electronics Forum | Wed Apr 02 10:51:17 EST 2003 | kmorris
Myu: Did you have to change your reflow profiles when you changed from 609 to 709? What ramp rate & time over liquidus are your profiles at?
Electronics Forum | Wed Apr 16 08:15:55 EDT 2003 | davef
Check with your temperature profile equipment supplier [eg, KIC, ECD, etc]. We use a download from ECD that lists most ovens and solder pastes that make it [or one like from another supplier] a good place to start.