Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Fri Sep 21 17:33:01 EDT 2018 | michaelszuch
Hello Hai, The first step is to determine where in the process the bubbles are being generated - either during coating or during curing. You can easily check this by letting a few boards air dry (no oven) and comparing them to the oven-cured ones. I
Electronics Forum | Fri Apr 26 05:56:12 EDT 2019 | ppcbs
Check out our line of Shuttle Star BGA Rework Stations. We just sold two model SV560 to a client with the same problem. Our prices include training on machine set up, profile development, process implementation and an operator certificate. We ha
Electronics Forum | Sun Feb 24 11:16:12 EST 2019 | proy
Guys, I have been down this road also spent a lot of time working on this. Electrolytics often are difficult to solder like this. For the sake of testing, try a water soluble more active flux as an initial test. IF you compare hand solder wetting the
Electronics Forum | Fri Apr 26 05:43:50 EDT 2019 | ppcbs
Check out our line of Shuttle Star BGA Rework Stations. Our model SV550 is $18,500.00 installed. Installation includes training on machine set up, profile development, process implementation and operator certificate. We have been providing rework se
Electronics Forum | Thu Mar 28 15:53:49 EDT 2019 | SMTA-Jon
As a CM, we don’t have a lot of input on the PCB layouts we receive. Some engineers/software packages output the paste layer 1 to 1, some do an across the board reduction, and some set each part up individually with different reductions per footprin
Electronics Forum | Tue May 28 18:31:08 EDT 2019 | jlawson
Solder paste flux is main contributor, Lead termination chemical-oxide by products and PCB Plating-Chemicals. Reflow profile would have very limited if not no impact really unless is way off. Paste volume control and Stencil design plays a big part
Electronics Forum | Wed Jul 31 07:51:31 EDT 2019 | ameenullakhan
Hi Dave, lead is 80Pb/20Sn. Top joint off CCGA lead is SN63/Pb37. Thermocouple was placed at center lead of the CCGA and one at the corner lead of CCGA. Ramp Rate Center 1.09 Corner 1.26 Soak ( 140 - 160 deg C ) Center 37sec Corner 38sec Ref
Electronics Forum | Fri Jul 26 09:34:10 EDT 2019 | spoiltforchoice
I've mostly been looking at the smallest oven in the range of the bigger ovens as it were. So that's the 1707 from Heller and similar sized units from elsewhere. However apparently Heller are apparently bring back the 1500 series in the form of a 150
Electronics Forum | Wed Aug 14 18:17:32 EDT 2019 | slthomas
We are down to the last few unresolved PCBA test failures in a work order and scrambling to get them repaired and into a mechanical assembly. What we have found in quite a few of these cases are cracked 1206 MLCCs. The failed parts are all the same
