Electronics Forum | Thu Apr 04 12:52:48 EDT 2019 | rodrigo
Hi, Our MCS30 had a bad backup battery in one of the boards. After changing the battery I got the all boot devices failed error. I managed to get a hold of some boot floppy disks and I can use disk1 to boot the MCS30 to a "$" prompt. I also have a di
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Mon May 13 12:50:35 EDT 2019 | robl
Hi Spoiltforchoice, it depends on what you pay for the printers new, but last time I looked there wasn't much difference in price between the DEKs and the Speedprint if you were buying multiple units. Remember there is huge markups on SMT kit. From
Electronics Forum | Mon Jul 01 14:46:47 EDT 2019 | assuredtech
It's been awhile but yes, if you do not allow the machine to optimize your program and your placing sequence is such that the tallest component is perhaps the 1st or last placement so it doesn't bump into other components, next is you may look into a
Electronics Forum | Tue Sep 24 15:32:22 EDT 2019 | kurtiss
During production our MPM Accuflex stopped working. When going into "Play" mode to run production it almost instantly Pauses. When going into vision setup it fails to load the PCB saying "The PCB Did Not Load". Ignoring this error and trying to read
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Wed Nov 27 08:54:03 EST 2019 | ttheis
Hi Tushar, Thanks for the reply. I do believe I put it into debug mode but I will be sure to check next time I try logicomm. I am not using any RAMTF or PTF. At the moment I have upgraded the machine from EPC-5 to EPC-5-66 which I found cheap. The
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Tue Nov 12 09:04:21 EST 2019 | mario85
Hello Guys, I'm new here. I am smt process engineer in new company located in Poland. I am responsible for whole smt line, so I have a lot of problems at the beginning :). I would like to ask about few things. The topic is solder balls. I produced s
Electronics Forum | Wed Nov 27 08:01:15 EST 2019 | tsvetan
Hi, Recent power blackout damaged our SONY F209 UPS ATA power supply and machine's HDD got corrupted at the same time. Power supply is replaced, but now the machine refuses to boot. The registry file for windows NT 2000 with all software installati