Electronics Forum | Wed Mar 28 11:27:32 EDT 2007 | jmelson
Hello, I was the guy asking about doorway size for a Philips CSM84. Well, we cut the doorway using the best info we could get, and managed to get the machine inside with only a few scratches on the paint! Still no door, hopefully the fabricator wil
Electronics Forum | Thu Jul 25 00:42:02 EDT 2013 | felo188
Hello everyone! I have problem with using vision in csm v60. Below describe: 1. Machine's third head takes one IC from tray 2. Goes to vision and take picture and moves IC 3. Goes to pick and place 4. When nozzle wants to place IC on board the
Electronics Forum | Fri Jul 26 20:20:06 EDT 2019 | kylehunter
This week we assembled around 30 panels of a LED board, totaling around 350 boards. In doing so we had to work around a really crazy issue. 1) A board goes in, all components are placed perfectly. 2) Next board goes in, all components are around 5m
Electronics Forum | Thu Oct 10 10:27:24 EDT 2019 | tsvetan
Omron is probably worst choice for AOI unless you have long series. Requires too much debug and there is always compromise between setting sharp criterias and get lot of fake errors or setting lose criterias and get boards with defects to pass OK. Y
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Tue Mar 13 19:27:33 EDT 2018 | maustin
I have an old Zevatech 740 machine that, until recently, was running well. In the last few weeks, the RH head has started giving me issues. When it picks up a component (and early on in most of my programs it will be picking up chip resistors or ca
Electronics Forum | Wed Feb 13 14:15:06 EST 2019 | slthomas
I don't see any attachments.....? Are the fiducials consistently well finished (perfectly round, shiny without splotches or other imperfections), or do they vary in quality? When you do a fid offset, is the correction consistent or do you get varie
Electronics Forum | Tue Mar 07 10:43:27 EST 2006 | dougs
The E has a different x-y table setup, i seem to remember the CP6 having rollers and cams to control the z table height, the CP6E has a belt driven z axis. Also i think the CP6E is slightly faster, 44K cph against 40K, still just program it as a CP6
Electronics Forum | Mon Aug 13 14:11:14 EDT 2007 | jeffharley
Slot 11 in the I/O box is the one for B.E.C. pcb, the offset is 2125 in the x and 500 in the y axis. The template for the B.E.C. is triangle in shape and is the length from corner to corner on the rotary table. You can also type in sh sys and look to
winsouce.jpg)
