Electronics Forum | Fri May 26 10:59:56 EDT 2006 | James H
I have a panel with 4 boards on it. All boards have the same orientation. Is there a way to set up an offset to make the program more efficient? I also have a few panels with a couple bad boards on them. Is there a way to set up the program to reco
Electronics Forum | Tue Jun 13 08:27:19 EDT 2006 | wrongway
Hello Mark level 4 error need to header initialize its under program data as far as mdI01 error looks like a flag field error check the F field for the item codes or fiducial codes. MDI03 error fiducial mark is not aquired need to aquire the f
Electronics Forum | Mon Jul 24 10:00:08 EDT 2006 | SWAG
I think I read a thread very similar the other day but can't find it. If I remember correctly, the component database for that part was polarized and pre-orientation was used for camera inspection. It turned out that the optimization module in the
Electronics Forum | Thu Jul 27 11:27:39 EDT 2006 | gregcr
Hi All, Wondering if anyone is using this Autosplice CC-112 Pin inserter. We have one here and I am wondering if there is offline software or a serial communication spec that is used to load programs in from a PC. We can make changes on the unit i
Electronics Forum | Sun Aug 13 14:01:56 EDT 2006 | bobpan
My guess would be a couple of months to go into 'FULL' production. Learning the software and debugging programs takes time. If you already know how to run the machines you are purchasing then things will happen faster. If you are learning to run all
Electronics Forum | Tue Aug 22 10:51:49 EDT 2006 | rmitchell
Hi, Hope your machine is back up and running. Are you sure it is not program or PD (part library) related? Try power off and back on and delete the machine program from the machine. Then- Power off and back on and see if the VP error is gone. It
Electronics Forum | Wed Sep 06 09:11:12 EDT 2006 | kkovachy
Cmiller is correct are not going to find a better machine for the price. Also I have used several different AOI platforms and the Yestech is hands down the easiest to program. Keep in mind that changing platforms is expensive. Operators, programmer
Electronics Forum | Wed Aug 30 10:09:08 EDT 2006 | digisys
I have an old Amistar MT-5500 which I use for small proto runs. Is someone has a copy of the off line programming software? It has 5 little programs useful to convert from PC protocol to Amistar. (tt.exe, 556edt.exe, 556fd.exe, 556mg.exe...) Mach
Electronics Forum | Mon Nov 13 09:37:14 EST 2006 | pforister
Hello, Is there an alternative program that I could use to program my Quad 2c and 4c machines? My 98 machine just crashed and the IT department does not want to re-load 98. I don't believe Autoprogram works on Windows NT, 2000 machines. I do know
Electronics Forum | Fri Dec 08 08:25:03 EST 2006 | jhaviland
Depending on the system you can program in a loop where if the board fails a contact to cycle the vacuum once or twice. it wears on the pins a little faster since you cycle 2 times (maybe more) per board but it could help increase the FPY. I know Gen