Electronics Forum | Sun May 25 10:30:31 EDT 2008 | necdetozyonum
Dear All, I would like to take your opinion about the result that we have faced after cleaning the PC assemblies in a cleaning machine (Miele Dishwasher) with the cleaning detergent Qualitek Everkleen 1005. We use DI water for cleaning purpose in t
Electronics Forum | Wed Jul 09 16:00:04 EDT 2008 | grics
Obviously you wouldnt perform the most difficult rework tasks till last... Sorry. I should have clarified. We rack our units to keep good units flowing and fall out are held for rework. The line never stops. Inspection is inline and it is the deci
Electronics Forum | Mon Aug 18 15:03:38 EDT 2008 | awegener
I'd like to get more information about pick and place nozzles. How can I learn more? ... What do the nozzles look like? Are there different shapes? Are custom nozzles sometimes used for custom parts or are the nozzles mostly standardized? What kind
Electronics Forum | Fri Sep 19 21:31:15 EDT 2008 | trynders
Thanks for the response guys! The parts are being sent to a local lab as we speak. I'll let you know the results when I get them. I am not sure the purpose of the copper band, but the black around the band is just shadowing from how I took the pi
Electronics Forum | Thu Oct 30 15:07:40 EDT 2008 | jemills
Hello I have a new 0402 pad design on a recent board were building in future. On closer look i thought the pad was a thru hole mount , but upon closer inspection the round pads are for 0402 comps. I had a discussion with the engineer and he said
Electronics Forum | Thu Oct 01 07:03:55 EDT 2009 | davef
We doubt that Humiseal 1A33 is causing opens in your assemblies. We'd guess the opens occur earlier in the process, but are not hard failures. So, you pass your tests. When applied, the conformal coat flows into the gap in the ball crack and insulate
Electronics Forum | Fri Nov 13 08:43:02 EST 2009 | herman
reash, Go directly to APS and get one of the APS GF-12 ovens. I have been using these for 15 years as a low-to-medium volume oven for general purpose reflow of CCAs up to about 12" by 12" with excellent results. I use them for BGA re-balling, underfi
Electronics Forum | Wed Jun 29 16:28:06 EDT 2011 | rway
Let's be more specific. Why do you need to clean the boards? I assume it is for testing purposes, probe contact concerns and the like. This is the only economical reason I can think of to clean no-clean flux residue from your assemblies. Before y
Electronics Forum | Sun Jul 01 10:29:46 EDT 2012 | anton99
Thanks dyoungquist and tech 1, Things have been crazy lately installing Mylabel and keeping up with customer demand. I have been looking into buying more reels for the high runners (caps, resistors, IC’s that we use a lot) and I think we have a shot
Electronics Forum | Wed Nov 07 15:01:18 EST 2012 | nikyta
Thanks Dave , my question is about Spopov want to try "Lead Free" SnBi (but uses it on Leaded finishes), but is worry about its low melting point (at this point, no longer 138 degrees as he wrote, but rather in an unknown and unpredictable range bet