Electronics Forum: qsp-2 z axis (Page 1 of 39)

mpm up2000 z axis hardware limit

Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze

that doesn't seem to be the issue here

mpm up2000 z axis hardware limit

Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit

I had as I placed the supports at the back - when lifting Z touched the rear rail - check.

mpm up2000 z axis hardware limit

Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze

Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d

mpm up2000 z axis hardware limit

Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1

Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts

mpm up2000 z axis sensor mount location needed

Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze

I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the

Axis head 2 z velocity error

Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG

Make sure the program has been optimized to the current nozzle configuration.

Axis head 2 z velocity error

Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb

Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the

Axis head 2 z velocity error

Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc

I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare

Axis head 2 z velocity error

Electronics Forum | Thu Jan 18 14:02:51 EST 2007 | geb

Thanks for your help everyone. For some reason it has started working again, without altering the program or settings!!?? So I don't actually know why it has done this. Thanks again, Grant

Axis head 2 z velocity error

Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika

zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba

  1 2 3 4 5 6 7 8 9 10 Next

qsp-2 z axis searches for Companies, Equipment, Machines, Suppliers & Information

Gordon Brothers October 2-30, 2024 Auction

Reflow Soldering 101 Training Course
Electronics Equipment Consignment

Nozzles, Feeders, Spare Parts - Siemens, Fuji, Juki, Yamaha, etc...
used smt parts china

Have you found a solution to REDUCE DISPENSE REWORK? Your answer is here.
Hot selling SMT spare parts and professional SMT machine solutions