Electronics Forum: qsv-1 (Page 1 of 9)

Quad qsv-1

Electronics Forum | Tue Jun 26 11:52:24 EDT 2018 | Dex

We are currently using a Fuji CP43 and a Fuji IPII, we have the opportunity to upgrade to a Quad qsv-1. I was hoping to get some input and basic knowledge of the qsv-1. Thank you!

Quad qsv-1

Electronics Forum | Tue Jun 26 15:02:55 EDT 2018 | jdengler

Why?

Quad qsv-1

Electronics Forum | Tue Jun 26 20:44:14 EDT 2018 | deanm

We have four QSV-1s, all with the Windows 7 upgrade. Although they do the job for us and they are still fully supported, I would not recommend them for anything less than 0603. For 0402 and 0201 you need special feeders. We do not use the special fee

Quad qsv-1

Electronics Forum | Fri Jun 29 03:29:06 EDT 2018 | robl

That's a significant drop in speed from a CP4/3 & IP2 to a Quad QSV-1 - about 75-80% slower. Also do you really want to go from one old platform to another? Obviously everything is budget dependant but there are a lot of newer used machines out

Quad qsv-1

Electronics Forum | Wed Jun 27 09:02:51 EDT 2018 | jdengler

A CP IV-3 is able to place 0402's very well. We do it all of the time with a CP IV-2. You need the right nozzles and feeders but no problem. I agree the ProSMT software is a pain but that's not the machine's fault. Jerry

Quad qsv-1

Electronics Forum | Wed Jun 27 08:47:02 EDT 2018 | Dex

What would you recommend? I am inquiring to see if this machine would include any of those 0402 or 0201 feeders. We have products that contain 0402s currently and it is a giant struggle with this CP43. We would like something that can place 0402 and

Quad qsv-1

Electronics Forum | Fri Jun 29 09:04:41 EDT 2018 | kdexter0928

Wow, its that much slower? If it were my decision we wouldn't be going from one old platform to another. As you said budget is the problem in this case. I am not sure that they want to spend the money on this let alone something newer. They would lik

Quad qsv-1

Electronics Forum | Tue Jun 26 15:27:14 EDT 2018 | Dex

Why would we change? our fuji equipment was previously owned by Motorola and have many hours on them. we struggle to place 0402 components and the vision system on the CP seems to be one foot in the grave. The machines are tired and have been ran har

quad qsv-1 gantry - quad align issues

Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator

Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.

quad qsv-1 gantry - quad align issues

Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad

Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is

  1 2 3 4 5 6 7 8 9 Next

qsv-1 searches for Companies, Equipment, Machines, Suppliers & Information