Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Mon Mar 28 10:26:55 EDT 2011 | miroyu
Hello everyone . I received lot of help from people of this forum for which I want to say "thank you" guys. I had problem whit initialization of my Quad 4C which just sits for 2 years after purchase. I manage to locate problem with laser diode on pla
Electronics Forum | Mon Oct 09 07:50:22 EDT 2006 | quad
We currently run two Quad IVC's (we are very pleased with them) and two Versatronics for simple small volume batch work. We now need an additional machine capable of placing components at least three times as quickly as a IVC. We don't do anything ve
