Electronics Forum | Tue Jul 12 17:21:34 EDT 2022 | markhoch
It is possible. If the talcum powder mixes with the chain lubricant, it could gum everything up. Back a few years ago when I was running an SMT Quattro Peak, I was having an issue with the conveyor chain drive motor going into overload. We had to pul
Electronics Forum | Sun Jul 03 03:52:40 EDT 2022 | acouto
I have some engine over load problems in the central reel, has it been identified that the external team misuses talcum powder for rubbers and many times we find talcum powder in the shafts, however will it be enough to cause the engine over load? Do
Electronics Forum | Thu Jul 14 03:16:18 EDT 2022 | acouto
Thanks for the feedback, I've been having some problems with the motor overload in the conveyor and central reel whenever there is cleaning by the external company. After analyzing I always find talcum powder and lubricant (it looks like cement) on t
Electronics Forum | Tue Jan 28 07:10:30 EST 2020 | spoiltforchoice
Looking at buying a new stencil frame. We are a small low volume, high mix place & can changeover stencils several times a day. There are several framing systems out there but most of them are Pneumatic.(VectorGuard,Zelflex,LTC Quattro) I've seen/h
Electronics Forum | Fri Feb 23 17:35:49 EST 2001 | mattias
Ok. F.Y.I How I could make this work: We use Almit V14, and SMT ovens. You can say that we don�t do our maintenance as good as we should. Our Smt Quattro peaks are equipped with process gas cleaning (wich works quite good actually) I ripped out the
Electronics Forum | Wed Mar 27 10:56:04 EST 2002 | gregp
Alas we as Americans are destined to be innovators and consumers. However, we do not consume what we innovate. We wait for the Euro and Japanese conglomerates to take our ideas, mass produce them, and then sell them back to us. They are fueled by
| 1 |
