Electronics Forum | Wed May 06 10:20:21 EDT 1998 | SMT-ASSY
Good morning, We would like to offer our services. SMT-ASSY is a training facility (Located in Dorval, Montreal area) which can introduce your workforce to SMT and the workmanship required to obtain quality products. We have attached our brochure in
Electronics Forum | Fri Mar 20 15:10:54 EST 1998 | Steve Abrahamson
| Cpk's on top flight ovens (e.g., Conceptronics, Heller, Electrovert, Vitronics) vary wildly, from 1 to 2+, between different supplers. The suppliers don't seem to understand Cpk's. A supplier's rep whose oven has a Cpk of 1.0 told me: | 1. Cpk's
Electronics Forum | Sat Mar 14 10:16:54 EST 1998 | Clyde F
| | | Can anyone give me any info on the effective removal of BGA's? I need to be able to take a variety of BGA's off boards quickly without creating pad damage. I am not yet concerned about the re-attach process. | | Hi Craig, | | I have been resear
Electronics Forum | Mon Dec 08 07:44:03 EST 1997 | Mika Johnsson
| I would like to hear from anyone producing high mix (~200 modules) with low volumes (5-2000 per year) using an automatic line running lot sizes in the 5-50 range. We are engaged in an investigation to invest in this capability. A view into the or
Electronics Forum | Tue Aug 07 20:40:19 EDT 2001 | davef
As Stefan says, it�s tough to comment on Linux / SCO features of Euroland machines, because you don�t see Linux. You can say Linux / SCO is faster, less crashy, and cheaper than Windows machines. [Same reasons most internet servers run Linux. Hmmm
Electronics Forum | Wed Aug 15 16:14:22 EDT 2001 | davef
Comparative Tracking Index [CTI]. In printed circuit board fabrication, CTI is a measure of the ability of the laminate surface to withstand tracking [carbonneous tracks on the surface, under wet contaminated conditions] across two electrodes placed
Electronics Forum | Thu Sep 13 13:29:06 EDT 2001 | mparker
Dave et al, I just print out and read a copy of the aforementioned recommended article. Mr. Mangin gives a clear picture of why DPMO is to be considered a more pure data than First Pass Yield (FPY). However, I must note that his interpretation of h
Electronics Forum | Fri Oct 05 16:05:58 EDT 2001 | seand
Hello everyone, Your chief variable here is going to be your epoxy. Different materials react accordingly to various inspection methods but, DEPENDING on your print parameters and material, you may be able to utilize an inline inspection machine.
Electronics Forum | Tue Nov 06 18:39:08 EST 2001 | MikeF
Also, check the website for Assembly magazine, http://www.assemblymag.com, they have some good information on the basics of torque. Determining the "correct" torque value can become very complicated very quickly. The same size screws made from differ
Electronics Forum | Mon Nov 26 14:49:20 EST 2001 | mparker
1. The formula for cubic area (LxWxH) applies to get the expected volume target value. Caution- do not assume the pad surface square are is correct for the part. Do consider the footprint of the device beign placed and its solder requirements to cre