Electronics Forum | Tue Apr 29 07:44:55 EDT 2014 | spoiltforchoice
Make sure you fully understand your own products requirements. How many components of each feeder type they will require? How many Feeder slots those feeders will require? How different each product is and how that will affect changeover times - whic
Electronics Forum | Mon Aug 25 12:43:35 EDT 2014 | freddimock
Numerous people use the Pyramax oven to process high temp solder but your success will depend upon the mass of your board. To maximize the probability of success you should use the highest convection rate (IWC) possible to enhance heat transfer an
Electronics Forum | Thu Nov 20 17:30:55 EST 2014 | gregcr
Hi All, I have a customer with a very dense design (24 layers, 0201's lots of micro-BGA and lead-less), and they run extreme data rates. Every once and a while they will have a unit that has some speed fall off and they attribute that to the possib
Electronics Forum | Thu Feb 05 02:30:00 EST 2015 | sarason
We were using TL1240Y Tack switches for 2 layered > PCB and posted those switches by hand. Now > planning to re-spin PCA where we recommend that > part to be added on SMT process. So looking for a > better and opt switch with same specs. Please
Electronics Forum | Tue Mar 31 09:22:48 EDT 2015 | rgduval
I've always hated using machine specs....they're always best case scenarios, and nearly never capture actual through-put rates. Personally, I don't like using first-piece rates, either...unless you're looking for worst case scenarios. Usually, the
Electronics Forum | Mon Nov 30 09:10:12 EST 2015 | spoiltforchoice
How do you cost the products you sell? We do contract work as well as building our own products but both work streams go through the same costing procedures. How you structure your costs really depends on your business. For instance, you can includ
Electronics Forum | Thu May 21 12:53:38 EDT 2020 | spoiltforchoice
A cheap piston compressor (like you might use in a garage) should be rated such that it has ~50% duty cycle, you don't want it running continuously. They are very affordable but do switch on and off between two essentially hardwired setpoints. The b
Electronics Forum | Mon May 25 20:51:13 EDT 2020 | kylehunter
> A cheap piston compressor (like you might use in > a garage) should be rated such that it has ~50% > duty cycle, you don't want it running > continuously. They are very affordable but do > switch on and off between two essentiall
Electronics Forum | Mon Mar 27 12:58:09 EDT 2023 | spoiltforchoice
> Full Load Amp (FLA) ratings on a nameplate > indicate that if you turned 100% of everything on > all at the exact same time with the flip of a > switch it would hit this FLA rating. Obviously, > this would be bad and is not the r
Electronics Forum | Tue Apr 13 14:49:15 EDT 2010 | davef
90%) from the sample, and the bake time and temperature specified herein are minimums. To improve test accuracy, or to prevent heat damage, other bake parameters may be AABUS. 2 Applicable Documents IPC-QL-653 Certification of Facilities that Inspect