Electronics Forum | Thu Nov 14 14:16:18 EST 2002 | ernman
In a low vol/high mix which would be the best. 3 Assembleon Topaz Xi's or 1 Universal 4796HSP & GSM
Electronics Forum | Wed Nov 27 21:40:50 EST 2002 | Yngwie
I have a question for you expert. Do you know the flammability ratings for all of the PCBA's ? what are the V0, V1, V2 representing ? Thank you.
Electronics Forum | Mon Dec 02 09:47:31 EST 2002 | brozinski
Hi Brad, have a look at our website http://www.ekra.com. Our screen printer E1 is rated best value amongst the semi autos. All the best.
Electronics Forum | Mon Mar 03 08:43:51 EST 2003 | markt
I can't seem to improve my machine utilization rate above 85%, what can I do to increase productivity on my placement machines?
Electronics Forum | Mon Mar 03 10:33:24 EST 2003 | Ben
We have a customer that is requesting decoupling capacitors, and we are not sure what they are or where to buy them. I know that the customer wants ceramic decaps. Should we just look for multi-layer ceramic capacitors with the rating the customer
Electronics Forum | Wed Mar 26 15:53:47 EST 2003 | russ
If you are applying paste, you should duplicate the profile recommended by the paste manufacturer. If you are applying flux only than you need to ensure that you do not exceed max temp and/or ramp-rates such as
Electronics Forum | Wed Apr 02 10:51:17 EST 2003 | kmorris
Myu: Did you have to change your reflow profiles when you changed from 609 to 709? What ramp rate & time over liquidus are your profiles at?
Electronics Forum | Mon May 05 03:53:41 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.
Electronics Forum | Mon May 05 03:53:47 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.
Electronics Forum | Fri Apr 25 09:17:47 EDT 2003 | Adam
We will soon be taking our first steps to place 0402's using a Europlacer Progress 6 pick & place machine.Even though the machine is rated at placing these chips, I was wondering if anyone has any practical experience and are prepared to share their