Electronics Forum | Sun Dec 14 09:27:29 EST 2008 | equipsolutions
I would recomend you a machine which neither requires big current ore airconsumption! Further all you should check sources of onsite support from vendor site, as I would recomend in many cases to order their service, then any second source supply! Fu
Electronics Forum | Mon Feb 09 20:06:15 EST 2009 | davef
Pallet fabricators are: * AGI; 177 Nick Fitcheard Rd NW, Huntsville, AL 35806; 256-858-3300 http://www.agicorp.com/ * Pentagon EMS; 10950 SW 5TH St, Suite 230, Beaverton, OR 97005; 503-924-2747 F503-924-2744 http://www.pentagon-ems.com * M&O Precis
Electronics Forum | Tue Feb 24 15:31:44 EST 2009 | pcbrookie
Wrongway - Interesting about the rails. I'll check to make sure operators are leaving a little 'wriggle room' on the rails in case they are in fact getting narrower in the middle. SWAG - I suspected the initial temp. might be a bit hot, thus causin
Electronics Forum | Wed Mar 25 20:00:32 EDT 2009 | davef
We are not sure what you mean by "any type like plastic, aluminum, stainless steel etc?" Binks [(US Corporate Offices), ITW Industrial Finishing, 195 Internationale Blvd., Glendale Heights, IL 60139; 630-237-5000 888-992-4657 http://www.binks.com] m
Electronics Forum | Thu Apr 30 08:33:42 EDT 2009 | kpm135
In regards to your panelized PCB it sounds like your step and repeat in you pnp program is slightly off, by 0.02mm from the sound of it. Are all of the components moving in the same direction as the fine pitched IC? I don't know what type of machin
Electronics Forum | Thu Jun 11 10:02:36 EDT 2009 | dyoungquist
Our cleaning process involves the assemblies being completely immersed in the water bath of the ultrasonic cleaner. The assembly has a QFP44 on it. Customer stated that when these assemblies have been cleaned with water in the past (at a different
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Fri Aug 28 08:52:13 EDT 2009 | duso02
Yes, you must thin Dow CC for any spray operations. We use Dow 2577 daily for multiple customers and we always thin it for spray operations and 2577 is considered medium viscosity. Dow recommends using up to 60% solvent (Xylene). Your 2620 is low vis
Electronics Forum | Wed Oct 14 09:01:16 EDT 2009 | jasonduerr
Hi, Everyone! What do you use for Assembly Drawings? I need Electronics Assembly Drafting software, and I am hoping to hear your recommendations. The core functionality I need is the ability to translate X/Y coordinates (ASCII file) to my Gerbers
Electronics Forum | Fri Oct 23 08:24:52 EDT 2009 | rgduval
Eric, I haven't used this oven; but, our Heller has built in profiling. Essentially, attach the thermo-couples to a board, and the appropriate point on the oven, and run a board (without parts). Your paste manufacturer will have published a reco