Electronics Forum | Thu May 23 18:05:07 EDT 2013 | hhaase
I'm going to be acquiring an older Kirsten Jet machine in the near future, but am having a bit of trouble locating a source for appropriate wave oil / ADL via a domestic US source. Their current recommendation is a product from Strub in Switzerlan
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Thu Jul 18 12:44:25 EDT 2013 | microaide
I don't recommend running AutoProgram in a Windows 95 virtual machine. It's really a Windows 3.1 application. The best way to run AutoProgram on a modern Windows computer is to install DosBox (a free open source DOS emulator that runs under Windows).
Electronics Forum | Mon Jul 08 13:10:55 EDT 2013 | rgduval
As with any issue like this, your miileage may vary with suggestions....but, here are the items I would consider: 1. Clinch tightness. I believe IPC gives a recommendation on the amount of bend in a clinched lead; make sure you're not beyond that.
Electronics Forum | Tue Jul 23 13:36:52 EDT 2013 | jsmorse
Does anyone have info on the "Cycle Steel" function on the Fuji XP141 machines. I am new to the industry and have not had any luck finding information on it. I talked to Fuji and they just tell me to leave it on, it will help with placement. We hav
Electronics Forum | Wed Sep 11 15:12:02 EDT 2013 | rway
"Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts?" That depends. It will still save time if your lot sizes are small, as opposed to hand placement. I would not recommend buying an
Electronics Forum | Sat Sep 14 23:45:44 EDT 2013 | jandon
How many operator/technician/engineer do you recommend for following SMT assembly line to achieve good uptime and smoothly running quality inspection, NPI process, tehcnical support and maintenance at the same time: - Single shift, 8 hours/day - Pri
Electronics Forum | Wed Sep 18 14:12:40 EDT 2013 | pjchonis
Hello Bachman. SAC305 is the most common lead-free solder alloy, not only for wave soldering but also selective. Most of our selective customers (especially automotive) are using SAC305. What is more important than the alloy to consider is the flux
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source
Electronics Forum | Fri Apr 04 13:03:00 EDT 2014 | jyo_409
What is the inspection procedure How to test leakage current Is 100% checking is required at IGI inspection What is the shelf life of the capacitor How much period shelf life is recommended for these capacitors How to check the ripple current of thes