Electronics Forum | Mon Jun 08 11:39:28 EDT 1998 | Earl Moon
| How do I mechanically/visually inspect BGA devices when they are soldered to a PCB for possible solder, or other, defects as a first step before part removal and further analysis? I have had board failures due to poor soldering--I think? I can pr
Electronics Forum | Mon Jun 08 21:01:23 EDT 1998 | Dave F
| In our continued search for another flex machine, we reconsidered Philips | Emerald (low Vol/high mix Mfg). We already have a CSM so it makes a little sense. Then the salesman started talking about the Topaz. The Topaz supposedly is "practically th
Electronics Forum | Fri Jun 05 15:06:26 EDT 1998 | Dave F
| I have just been assigned to look into the ionic chromotograhy test on our PCBA but I have zero knowledge. Could anyone help to explain what is this test about? Is it | a) a destructive test? | b) What is the measurement unit of this test? | c) Wh
Electronics Forum | Sat May 30 18:33:02 EDT 1998 | Earl Moon
This message is to Cunli and his great staff who keep us flying straight and level while reminding us always to keep our nose down in the turns. (can't keep from doing some of that pilot "s__t" Mav. I, I mean we, would like to post some tempters as a
Electronics Forum | Mon Jun 01 09:32:29 EDT 1998 | Dave F
| This message is to Cunli and his great staff who keep us flying straight and level while reminding us always to keep our nose down in the turns. (can't keep from doing some of that pilot "s__t" Mav. | I, I mean we, would like to post some tempters
Electronics Forum | Mon Jun 08 21:20:55 EDT 1998 | Dave F
| | | Is there someone who can tell me where I can buy rolls of leader tape for SMT component tapes. Is there a good way of bonding leader tapes, maybe a special instrument to do the job. Thanks for any help. | | Igmar: The following companies suppl
Electronics Forum | Sat Jun 13 00:25:59 EDT 1998 | Scott McKee
Last October I purchased a Mydata over a Phillips and Amistar. I've done things on my Mydata that is impossible on the other machines. I can build the top side and the bottom side of two boards at the same time (I print both sides at once). I can "
Electronics Forum | Tue May 26 15:53:39 EDT 1998 | Chrys
| We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized to
Electronics Forum | Tue May 26 16:35:53 EDT 1998 | Ryan Jennens
| | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized
Electronics Forum | Wed May 27 10:15:52 EDT 1998 | Doug Romm
Just wanted to add a few comments on the discussion of how to identify palladium parts. Generally, there is no "clear-cut" way to identify Pd versus Sn/Pb. It mainly comes with experience. Any part that is is plated prior to being trim/formed will