Electronics Forum | Thu Apr 07 09:24:47 EDT 2011 | rway
What version of sw are you running? There are some new features in 2.7.7 and earlier that may be of benefit to you. With chip caps you are testing for presense/absense. The gain/offset feature can be used to give you better contrast between the pa
Electronics Forum | Tue Aug 30 11:13:23 EDT 2011 | markaustin
Hello Bill A colleague here at ACW just told me about your question and as we have a few of these machines I feel that I'm in a position to answer you. Prior to 2007 we only used DEK265 (GS & GSX) machines and these we getting a bit old and passed
Electronics Forum | Sat Oct 01 20:31:19 EDT 2011 | assybkr
fishingfool, I would appear obvious that you are connected to Yestech since only inside information could make your statement in paragraph two. I hate to break it to you but a $15,000.00 ransom is exorbitant, most equipment suppliers are half if no
Electronics Forum | Fri Nov 04 22:12:57 EDT 2011 | machinehead
I know what you mean but have never found a tool > that would do this sufficiently. For higher > value parts you should keep them in a bag for the > next time you run a job that uses that part and > hand fit them. > > The nature of the feeders
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Fri Dec 09 15:10:55 EST 2011 | davef
Can you use the equipment manual as the basis for learning how to use the machine? Each model of printer has different alignment techniques. We don't have a clue of your model type. So, we'll approach the question from its most basic point. Registe
Electronics Forum | Tue Feb 21 17:08:16 EST 2012 | cellis
We finally can't avoid adding wave solder to our > process anymore. For lead-free, medium sized wave > I'm leaning towards mid 2000s senju units as the > best fit. I've never run their equipment. > Opinions? > > As a point of reference for our
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D
Electronics Forum | Wed Mar 21 20:02:37 EDT 2012 | hegemon
Lead Free in 5 zones is tough sledding. Start with your manufacturers solder reflow profile and calculate your belt speed by looking at the recommended heating time for the solder paste vs. the length of your heated zones. Set your belt speed so tha
Electronics Forum | Tue Apr 24 09:30:43 EDT 2012 | bdamico
Hello Laritzstange, My name is Brian D'Amico, I am the president of MIRTEC USA. I noticed your posting on this forum and I would like to offer some guidance. First, I would like to ask which system you have. Our MV-7 system is an in-line system.
