Electronics Forum | Thu Jun 11 09:34:11 EDT 1998 | Mike Moninger
I'm surprised there hasn't been a response to this. This technique has been around for some time, as it was used early on for memory boards and the like. The pins come on a reel with a carrier strip or strips. Machines are available from the manufact
Electronics Forum | Fri Apr 17 08:51:26 EDT 1998 | Stefan Witte
| We are looking for some basic mechanical parts to | advance parts in the Tape & Reel Carrier Tape using | a stepmotor. The Carrier Tape we use is as per the | EIA Standards and I imagine there are dozens of | companies that make a sprocket gear t
Electronics Forum | Wed Apr 15 23:30:27 EDT 1998 | Scott McKee
| Wondering if anyone has information on percentage of components that we | can expect to "lose" during our SMT process. We are new to SMT, using | QUAD machines and feel we are losing to many parts during our process. | We are spending a lot of tou
Electronics Forum | Mon Dec 29 14:42:00 EST 1997 | justin medernach
| Hello all, | I have experienced broken ceramic SMT parts. Most of the time, | we have found fractured inductive beads. Once in awhile, we find | broken Ceramic Caps. All parts we use are 1206 form factors and | we use tape and reel... | Michael
Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Fri Nov 09 20:33:28 EST 2001 | caldon
There is two directions I see here...1) you are looking for a bid comaprison or 2) you are going to build boards with the machines you cause they are not being used in full capasity. Some OEMs and/or CEMs charge extra for "cut tape" (Not full reel)c
Electronics Forum | Thu Nov 22 12:51:03 EST 2001 | Claude_Couture
One of the points brought forward on this discussion is the level of responsibility the management wants to give the operators. The more responsabilities = higher salary.therefore, in order to save money in salaries, the operators are not held accoun
Electronics Forum | Mon Feb 11 13:00:00 EST 2002 | Roy Barton
I am looking for some equipment with a fairly undemanding capability. I would appreciate pointers to potential suppliers. Dispense size 0603 chips only, speed can be as low as 60 chips per minute. Only one type of component (ie one reel) is loaded.
Electronics Forum | Fri Apr 19 12:39:10 EDT 2002 | Yannick
Hi Our compagny is in a high Mix, low quantit� production, We have so much trouble with the IC because the buyers don't wnat to pay to have the IC in a reel so we use a vibratory. Some operator are very good to make the vibratory work well but so
Electronics Forum | Wed May 08 09:49:17 EDT 2002 | Hussman69
Hello, We are experiencing a little problem of cutting feeder tape. When ever we place two or more 24 mm feeders together, the cutter on the machine will partialy cut the adjoining tape, or pull it out of sequence. The machine is a Panasonic MSR,