Electronics Forum | Thu Dec 08 13:34:46 EST 2016 | spitkis2
We are currently experiencing with our SMD Solder > Reflow Equipment on Shooting-Up Zones (Zones > 3,4,5,7 & even Cooling Zone). PV exceeds about > 5-10 degrees with the SP. (ex: SP=140deg, actual > PV = 145deg & higher). Our equipment undergo a
Electronics Forum | Mon May 14 09:04:58 EDT 2018 | raylawre
We are using ECD OvenRIDER to validate our reflow ovens on a weekly basis to have the data to show our customers that the board we ran 3 months ago saw the same oven condition as the one ran yesterday. Cp/ Cpk is calculated by ECD using a manually i
Electronics Forum | Fri Oct 29 09:45:08 EDT 2004 | pioneertechnology
In 1995 we bought 4 Vitronics U520 reflow ovens with top heat only. We ran these ovens until 2003 for both curing and lead reflow with no problems. In 1998 we bought 1 U520 top and bottom heat and one U820 top and bottom heat and once again we had
Electronics Forum | Wed Jul 20 12:48:50 EDT 2005 | danhui888
Dear All, I'm looking for the complete SMT > equiment line (solder printer, P&P, Reflow) uses > for the small volume production line. I happen to > know that Manncorp and APSGold can provide the > complete ST line, but I haven't hear and use > t
Electronics Forum | Wed May 21 13:26:46 EDT 2003 | Brian W.
Something else to keep in mind when you reflow using an IR (non-convection) oven. IR reflow is more susceptible to variations in board mass and coloration than convection ovens. Hi mass areas and dark colored parts will cause more variation in your
Electronics Forum | Mon Jun 11 14:25:36 EDT 2001 | CPI
I had the very same problem but, did not question my oven as I knew the profile was good and I should have had even heating. So I then looked at pad size and layout. When Layout and size were found to be ok. I attached a prob to each pad and ran a pr
Electronics Forum | Tue Oct 12 15:20:44 EDT 1999 | Jim Schultz
I need your help! We have been doing double sided surface mount for 4 years now. Up until 6 months ago I have not had a tombstoning problem. Since then I have a fairly high incidence rate of tombstones on the 0603 size resistors (no other parts).
Electronics Forum | Wed Aug 04 16:55:32 EDT 1999 | Doug
| We are installing a new reflow oven and I have been told that we do not need to vent the exhaust out through the roof since we have a false ceiling. All that is required is to vent above the false ceiling and that the air exchange is great enough t
Electronics Forum | Sun Jan 31 14:03:41 EST 1999 | Dean
| I have a recent design (1 component side only) that calls for 2 surface mounted antenna's (brass plated) to be mounted on a PCB. The problem arises when the PCB is 18x11.25 and has 15 to 20 PCB's in the pallet (IE weight, fixturing to hold the ant
Electronics Forum | Wed Apr 14 23:16:07 EDT 1999 | wil allen
| Need to know from your experience a set of smt equipment for low volume manufacturing (approx. 800K parts/yr). Types to handle are standards i.e., 0404-7343, soic's, plcc's, pqfp, tsop, soj, BGA, chip res. smt conn. | I would like to know a recomm