Electronics Forum | Mon May 20 08:45:06 EDT 2013 | markhoch
Delta T usually refers to the Temperature Difference between adjoining zones in your Reflow Oven. The recommended Delta-T between heating zones is http://www.ipcoutlook.org/pdf/best_practices_reflow_profiling.pdf
Electronics Forum | Thu May 23 09:25:39 EDT 2013 | cyber_wolf
How many of you run a different oven recipe for the secondary side of a double sided reflow assembly. In other words, would you use the same recipe for both sides ?
Electronics Forum | Thu May 23 10:29:15 EDT 2013 | emeto
We would usually have the bottom zones at the reflow with 10 degrees less than the top ones for the secondary side. This we proved helps to keep the parts of the primary side on the board.
Electronics Forum | Mon Jun 09 11:11:57 EDT 2014 | cyber_wolf
What does the technical data sheet for the component recommend for reflow profile ? Can you post a photo of the component ?
Electronics Forum | Mon Oct 09 05:57:33 EDT 2017 | jamesbarnhart
Reflow profiling/soldering is a process in which a solder paste (a sticky mixture of powdered solder and flux) is used to temporarily attach one or several electrical components to their contact pads, after which the entire assembly is subjected to c
Electronics Forum | Tue May 07 10:13:06 EDT 2019 | cyber_wolf
I have personally never seen a reflow profile change reduce voids. We have invited "experts" in to demonstrate this claim. They were unable to.
Electronics Forum | Mon May 27 04:36:08 EDT 2019 | SMTA-Rogers
Dear Sr.Tech, We tried to adjust the soak time and TAL time of reflow profile, but it doesn’t seem to help much.
Electronics Forum | Mon May 27 04:40:21 EDT 2019 | SMTA-Rogers
Dear Steve, We already to do some DOE of reflow profile, but the optimized parameters are not help for the reduction of voids.
Electronics Forum | Mon May 27 04:46:11 EDT 2019 | SMTA-Rogers
Dear CW, Yes, we also tested many different brands and models of solder paste, under the same stencil design and reflow profile the condition of the voids will have great difference.
Electronics Forum | Thu Dec 26 13:28:08 EST 2019 | emeto
Show us your reflow profile. Most probably that will help us to troubleshoot better.