Electronics Forum | Thu Nov 16 08:57:00 EST 2017 | jandon
We found used Ersa HotFlow 2/14 reflow oven that does not have bottom side preheaters. Can it be easily and safely used in normal high mix/low volume production or is it built for specific products which does not need bottom preheaters?
Electronics Forum | Thu Nov 16 22:01:06 EST 2017 | deanm
That model comes standard without bottom preheaters. Bottom preheaters are an option so I would think it is designed for general use unless you have some very thermally challenging boards. As long as you are within the process window, you'll be fine.
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho
Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you
Electronics Forum | Thu Apr 15 20:41:22 EDT 2004 | Ken
There are ledgitimate reasons for checking furnace calibrations, but let me clarify what that is. 1. TC's are not necessarily calibrted. Not unless you need "absolute" accuracy. TC's operate against a (non-linear) standard +/- a tolerance. Most
Electronics Forum | Fri Apr 16 07:34:10 EDT 2004 | Claude_Couture
Ken, thanks for your answer, it is much better presented than what I was fed by our qc. By "calibrating TCs" I meant the readings the controller is displaying on the screen. So that would be the converter that we would check and calibrate. Thank you
Electronics Forum | Thu Jun 27 03:03:57 EDT 2019 | SMTA-David
Hi, I have a small assembly line that consists of a Semi-Automatic Stencil machine, a Samsung Pick and Place, a small IR reflow oven and a wave soldering machine. The reflow oven is presenting the biggest bottleneck. The machine is a small IR (T960