Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Thu Apr 19 16:08:36 EDT 2012 | rodrigo
Hi all, I'm still trying to get our CP4 to work. I've found 3 relays with bad contacts but replacing them didn't help (weird). I'm trying to check the input lines to the Direct I/O PLC. Could someone take a picture of the LEDs (IN1-3 and OUT1-3) aft
Electronics Forum | Mon Aug 05 10:06:41 EDT 2013 | stevevb
Hello Scotty, As a CM, your first process should be new. We bought a Quadra P&P centric line to build our solid state relay products and loved it so much, we (VB Controls) became a TWS Automation distributor. Recommendation: 2700 semi-automatic s
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Sat Nov 15 05:08:45 EST 2014 | grimus
Same side (component side) if You give me e-mail I can provide You more pictures. I'm making one stroke with same speed (I'm using closed proflow head and DEK printer). 5 mils thickness stencil. Products requirement - 3 IPC Class (75 % and more fill
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Tue Jan 05 17:32:51 EST 2016 | taiji
We have a TDK radial machine VC-7C, The "DNC CUT" button doesn't change state, the machine shows alarm "904 ALM CRD RX RECEIVE 800", We already check button and relay and working OK, Also check the cables and also OK. We have no idea where else to lo
Electronics Forum | Thu May 02 13:40:25 EDT 2019 | youngbuck
Hello All, I am having a issue with Siplace 80 F5 with parts placing of in the X direction after I do Zero Point Correction with tool and Full Calibration. I also do the Gantry Zero Point correction and parts still place off in the X about .200mm to