Electronics Forum | Thu May 13 17:11:48 EDT 2004 | Longhua
We are looking for PCB suppliers capable of building .5mm through hole boards. Internally, we require 5 mil traces, sometimes 4 mil. Our preferred material is Polyimide or BT Resin, and perhaps FR408. All help and/or recommendations is greatly appre
Electronics Forum | Tue Nov 22 09:52:57 EST 2005 | moonshine
Might be resin smear. Check out all the stuff on my free site as articles, photos of almost every board defect imagineable plus much more. Did I mention, It's ALL FREE ALL THE TIME? MoonMan
Electronics Forum | Sat Apr 26 08:18:47 EDT 2008 | davef
Your warpage problem could be caused by change in: * Multilayer board construction (not homogeneous or unbalanced - too resin rich or poor) * Supplier process capabilities (lamination cycles) * Material selections (usually cheap and dirty), etc.
Electronics Forum | Thu May 27 15:59:30 EDT 2010 | mikesewell
ATS-667 tape. You can buy direct http://www.ats24.com/index.cfm?fuseaction=content.display&contentid=50 or through distribution such as All-Spec. Polyester film with rubber resin adhesive (no silicone) = clean mask lines. Call for a sample.