Electronics Forum: retire and hours (Page 1 of 11)

Time to retire the wave?

Electronics Forum | Sun May 27 04:18:22 EDT 2007 | grantp

Hi, We are currently soldering only connectors, so there is not that much to do. For the wave we currently use palettes as we solder PCI cards but don't want to wash. So the palette keeps the flux off the board. My reasons for looking at changing o

Manncorp Pick and Place

Electronics Forum | Sun Aug 03 09:44:10 EDT 2014 | isd_jwendell

I have 2 experiences with Manncorp machines and support, both were not good. Example: One manual was written in Japanese. I requested an English version, but was told it doesn't exist so too bad. I had to pay a local translator to get what Manncorp

Re: Siemens HS50 and F5 and S25

Electronics Forum | Tue Nov 28 16:28:14 EST 2000 | CAL

Chris- The machines you identified are stable products and have been around for over two years now and most bugs have been worked out. The F5 IC head has not changed much since its introduction over 5 years ago. Remember these machine like to run, r

Stencil cleanliness and inspection

Electronics Forum | Wed Jun 06 21:19:41 EDT 2001 | davef

Consider running two sets of stencils and washing every four hours.

small and good pick and place machine

Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao

There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total

tape and reel vendor

Electronics Forum | Mon Mar 22 13:07:25 EST 2004 | Richard Y

Try these guys out: http://www.cornetttapingproducts.com/ Tell the owner Chuck I reffered you. He's a great guy and is very reasonable. He even gives me hours in turn times AND that's making the tape and T&R the parts!

Pick and place pickle

Electronics Forum | Mon Jun 09 18:43:54 EDT 2008 | mowens

Hello everyone, I'm a long time reader of the forums but this will be my first time posting and seeking help. Here's our situation, we have a small pick and place it places about 1800 parts per hour. It is a good R/D proto machine, but it is quic

Stencil cleanliness and inspection

Electronics Forum | Thu Jun 07 13:40:12 EDT 2001 | kerryn

Dave, We have very short runs (less than one hour). We have stencils all over the place waiting to be cleaned. It is too time consuming to scope each stencil to inspect for cleanliness. Do you know of any automated or scanning devices that can ra

Cp and Cpk values

Electronics Forum | Mon Mar 03 11:06:13 EST 2003 | msivigny

Hi floydl, I completely understand when it comes to data crunching after long hours of performing measurements, it's the last and most important arduous task in obtaining performance data. If a measurement and evaluation process that traditionally to

Mydata Pick and place

Electronics Forum | Sun Aug 26 12:40:59 EDT 2001 | stefwitt

I would like to enter the discussion by tossing some numbers in. First of all I don�t like the 3 Sigma value. 3 Sigma are 2000 defects per mio. if I remember correctly. This means, if you have 200 components on the board, then every 10 boards have on

  1 2 3 4 5 6 7 8 9 10 Next

retire and hours searches for Companies, Equipment, Machines, Suppliers & Information