Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Fri Feb 01 13:09:16 EST 2013 | emeto
I am glad you got it. It had to be one of these.
Electronics Forum | Wed Jan 30 11:27:44 EST 2013 | ericrr
----- More ------ Due to the need to keep to run going while waiting fo the repair joker to emerge, are doing the run on just two machines.It turns out that when the faulty machine has been left on for two hours the fault disappears and the machine w
Electronics Forum | Fri Feb 01 12:52:31 EST 2013 | ericrr
Interesting enough, it did turn out to be alignment, maybe the machine is getting bend & twisted just like people do when they get old....... or maybe I should say as the beam gets less intense with old age the sensor needs to be readjusted to pick u
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Sat Feb 11 02:50:07 EST 2023 | dekhead
Please contact me directly; DEKHEAD@ATT.NET
Electronics Forum | Tue Feb 14 05:01:29 EST 2023 | leeg
Sounds like the brake may have gone?
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
.jpg)
