Electronics Forum: samsung power switch (Page 1 of 17)

Quad 4C power switch

Electronics Forum | Mon Aug 19 15:21:17 EDT 2013 | marcelorotofrance

Hi Rollon, thanks for your answer. At this point it seems that cold-start current surge, because the presence of large value capacitors in the power source, exceeds the sensitivity of the protection switches rather than a malfunction. Nevertheless, i

Quad 4C power switch

Electronics Forum | Fri Aug 16 03:13:32 EDT 2013 | rollon65

Hi Marcelo. I have used 2 non EU model 4C machines since 2002 that do this almost every time from a cold switch on. My local Tyco tech guy said that they all do it. They are still going after 12 years. I have another EU machine that does the sam

Quad 4C power switch

Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance

When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and

Quad 4C power switch

Electronics Forum | Thu Sep 12 20:55:39 EDT 2013 | marcelorotofrance

My own unit has an internal transformer also. It has multiple secondaries, and a divided primary which can be configured to the required voltage by changing jumpers. Best regards.

Quad 4C power switch

Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65

Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K

Samsung CP45FV NEO main start switch problem

Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits

So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk

Dek-265 no power

Electronics Forum | Wed Apr 30 08:03:25 EDT 2008 | chineechooze

You need switch out the cognex vision card.

Dek265 mk1 power problem

Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill

First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict

high power operation

Electronics Forum | Mon Aug 06 05:12:20 EDT 2007 | wayne_

Hi Is there any standard or requirement to test the solder under high power operation? For example, a power switching device, what is the failure mode of the solder joint after the whole equipment undergone a high power (current / voltage) environmen

Dek-265 no power

Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr

DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit

  1 2 3 4 5 6 7 8 9 10 Next

samsung power switch searches for Companies, Equipment, Machines, Suppliers & Information