Electronics Forum | Mon Feb 18 09:49:43 EST 2019 | bobpan
This is going from my memory from a long time ago...but in the scp.ini file....there could be digital light control and/or a matrix tray handler setting. I would turn them off if they are on. I believe this has something to do with a system setting.
Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw
Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.
Electronics Forum | Mon Feb 18 08:11:27 EST 2019 | tomazicrok3
hello i have samsung cp40cv and this errors comes up can someone help me. vision communication error(1000)(1000), no sequence-finished from handler(%1), no command response from handler (0x2002).
Electronics Forum | Tue Feb 19 02:03:51 EST 2019 | bukas
try first to replace SYS folder, or one by one of its files. if that doesnt work you are looking at complete disk backup. and check disk for bad sectors ofc
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Tue Jul 27 11:40:13 EDT 2021 | proceng1
Is this the tray feeder that comes with the SAMSUNG SMT machines? If so, I believe the SUPERVISOR password is 1000
Electronics Forum | Sat Jul 31 09:16:53 EDT 2021 | sophyluo1985
Dear Maddy, I'm Quinn form GOLDLAND, we have Samsung STF-100N Automatic tray feeder, if you are interested, please contact me Email: sales07@feedersupplier.com
Electronics Forum | Tue Apr 11 03:01:52 EDT 2017 | tsvetan
check if the top plate which is used for tray change is on it's place, also in manual mode you can see on Sig.IO page all sensors status and you can figure out which sensor is activated
Electronics Forum | Wed Nov 22 10:32:46 EST 2017 | itactilum
I need the soft for samsung cp40 lv + i can't find it. reinstall the s.o and I would need the soft. on the other hand it gives me an error that begins to give continuous beeps without stopping and I get the following error message "no sequence fini
Electronics Forum | Tue Nov 17 05:01:36 EST 2020 | empac
Hi Rob, we have the same problem on our cp40 : no sequence finished from handler could you let me know how you get into the sys.ini ?Thx. David
