Electronics Forum: says (Page 1 of 432)

Customer says

Electronics Forum | Mon Nov 13 12:17:58 EST 2017 | slthomas

Hi All, We have a new customer with a new design asking for us to leave the center VIP (8 mil drill) on a 9 ball uBGA (.5mm pitch) unplugged. What are my options should I be unable to convince them that this is going to be problematic? Obviously it

Quad IVc says

Electronics Forum | Fri Feb 27 06:14:43 EST 2015 | bobpan

press the control and output button at the same time to toggle back to v enter command. good luck

Quad IVc says

Electronics Forum | Thu Feb 26 12:58:21 EST 2015 | daniel_esposito

Hi everyone! I have P&P Quad IVc. The Hand Held Terminal (HHT)says "V idle" intead of "V ENTER CMD", and when it is running, the HHT shows commands lines each one at the same time it is running. One of our technician entered mistakenly, at the HHT,

Quad IVc says

Electronics Forum | Wed Mar 04 07:42:23 EST 2015 | daniel_esposito

Thank you Bob! I have followed your instructions and it is now running with "V CMD ENTER" at the HHT. Daniel

Lead-Free

Electronics Forum | Fri Jun 07 02:43:35 EDT 2002 | madreindeer

Thanks for answers....In Euroland (My place)it is not so clear.And this is confusing: There is 3 different comittee�s in Europe. First says 1 of January 2007.Second says 1 of January 2006, and third one says that any of these will do. Also we get a

yellow residue

Electronics Forum | Tue Aug 22 15:34:14 EDT 2006 | Chunks

Hi Steve, What type of flux? How do you apply it? What kind of wave? Rite off the cuff, I'd say you're applying too much flux, but without knowing a little more, it's tuff to say. It could even be board related. Hate to see what WML has to say

Epoxy for holding large inductors

Electronics Forum | Wed Jan 14 17:31:24 EST 2009 | swag

Doesn't sound like we use it exactly like your application. Similar to what davef says we use it for smaller to medium size or dense parts (sigle dot under the center of the part) that have potential to fall off on 2nd side processing. I can say it

Shoot Up Reflow Zone

Electronics Forum | Fri Dec 09 06:33:01 EST 2016 | cyber_wolf

Hold on Carlo, You are saying two different things, you are saying "(Zones 3,4,5,7 & even Cooling Zone). PV exceeds about 5-10 degrees with the SP. (ex: SP=140deg, actual PV = 145deg & higher). " Then you say: "the board reach up to 145 deg. 5 deg

Wave Solder Dwell Time

Electronics Forum | Sat Nov 04 20:17:25 EST 2000 | Greg G

Hi Guys, I'm sorry to ask you this, but I got mixed infos from the archive. I want to define a process in wave soldering regarding bd-wave interaction. Now "What's the required dwell Time of a lead in the solder bath?" Some says 3-5 secs is good, som

Re: Manual reflow using hot air.

Electronics Forum | Thu Nov 30 21:27:26 EST 2000 | Dave F

What is this equipment? What was the result of their training course? What does their factory support tech say? What does their local sales rep say?

  1 2 3 4 5 6 7 8 9 10 Next

says searches for Companies, Equipment, Machines, Suppliers & Information