Electronics Forum | Thu May 18 10:20:55 EDT 2006 | slthomas
Russ asks good questions and I think Chunks pretty much nailed it. Aspect ratio (aperture width/stencil thickness) s/b 1.2 minimum (I like 1.5 if I can get it). If your aperture width = lead width (.008"), yours is 1. Tough to get consistent paste r
Electronics Forum | Mon Sep 20 17:46:21 EDT 1999 | Dave F
| I've had some trouble pasting a test board for a MicroBGA trial. Most of the paste remains in the stencil apertures. | The stencil is 6 mil thick, laser cut and electo-polished. | The apertures are 12 mil in diameter with 20 mil pitch. | We are usi
Electronics Forum | Mon Oct 14 14:11:39 EDT 2013 | island2013
Yes, I agree with Evtimov. It's more about aperature reduction and type than it is the type of machine. Aspect and and Area Ratio are very important. Take a look at this page I found on the internet http://www.qualiecocircuits.co.nz/stencil-techno
Electronics Forum | Thu Mar 05 13:17:19 EST 1998 | Justin Medernach
| Hello everyone! | Does any know anything about bare board size variations? | Is there a spec. or tolerance? | I'm running small lots of boards and during the screen printing process | I find that I cannot paste each board perfectly.I've tried other
Electronics Forum | Thu Mar 05 23:33:53 EST 1998 | Ron Costa
| | Hello everyone! | | Does any know anything about bare board size variations? | | Is there a spec. or tolerance? | | I'm running small lots of boards and during the screen printing process | | I find that I cannot paste each board perfectly.I've t
Electronics Forum | Fri Mar 06 10:30:46 EST 1998 | Ron Costa
| | | Hello everyone! | | | Does any know anything about bare board size variations? | | | Is there a spec. or tolerance? | | | I'm running small lots of boards and during the screen printing process | | | I find that I cannot paste each board perfec
Electronics Forum | Thu Oct 02 17:00:44 EDT 2008 | davef
Is that accurate? If so, what are your aspect & area ratios? [Similar to the JerryS comment above.] * You say, � � and the average height is very high: nearly 200 pct.� => Our troop can make paste that height too. They snap the stencil-off a fast as
Electronics Forum | Fri Jul 16 03:11:23 EDT 1999 | SPEZZAFERRI Luca
| | | Hi, | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | | | | | Sec
Electronics Forum | Wed Sep 20 19:34:13 EDT 2000 | Dave F
Congrats. You now control the source of almost 70% of the defects of your SMT operation. There is a neat series of presentations on printing, each year at SMI. One of the best of the SMI series was in 1997, because presenters used a common board
Electronics Forum | Tue Apr 01 18:21:48 EST 2003 | slthomas
I've never printed adhesive but I assume that aspect ratio still plays a part with release. Maybe that .006" is just to thick to get good release. Can you step your stencil down from .006" to .004" or .005" for the 0402's?
winsouce.jpg)
