Electronics Forum | Sat Sep 25 09:00:59 EDT 2010 | slwolbert
I managed to bypass this issue by flushing FIP2 and sending status and proper back.
Electronics Forum | Mon Aug 31 09:53:59 EDT 2009 | fujiphil
after sending all the datas.... proper, program and status... Re-boot the machine...
Electronics Forum | Wed Apr 12 07:44:22 EDT 2017 | oxygensmd
Is it possible to send me any documentation about Siplace S-feeders? I have some but I'm looking for manuals, repair guides to let me maintance the feeders properly. Thank you very much for any help!
Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Tue Aug 22 18:32:42 EDT 2006 | daxman
Thanks for your posts fellas. The machine is still down. I have tried flushing the machine, re-sending the proper and status, and booting without a program. Still no luck. I did receive an OS error, the code pointed to the CPU card. So I replaced i
Electronics Forum | Thu Aug 29 14:41:10 EDT 2013 | kdc45
We found we had a bad communication cable which caused all of the files to be corrupted. We then held the RESET down while powering up and it successfully dumped. We were then able to send status, proper and programs to the machines. Hope this helps
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Fri Dec 08 10:24:11 EST 2006 | pjc
The Speedline Technologies- Electrovert AquaStorm 200 is one machine that can do the trick. You'll need the Chemical Isolation option for the RMA flux and you'll need a cleaning chemistry like what Zestron and Kyzen have. Yes, hi-density boards with
Electronics Forum | Wed Oct 12 22:22:31 EDT 2005 | zl3vlf
Hi all! Well installing the servo card has fixed the status LED issue....however there is a new problem :( When a production program is executed at the IP3 (pressing AUTO or START) the machine says 'communicating with the VP' (which is normal). Wh
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
