Electronics Forum | Wed May 21 02:15:26 EDT 2014 | aflex
Not very sure of. But can help you in getting the right actuators. Contact this company http://www.venturemfgco.com/. They got a good name in actuator manufacturing. For any PCB requirement contact us for the best deal.
Electronics Forum | Wed May 21 03:59:05 EDT 2014 | aj
Hi, If you can advise any assembly issues or concerns regarding this type of part and also... 1 - Can you confirm that they come in tape & reel format? 2 - Is it a requirement to have a glue dot in the centre of the pcb pads? Thanks, AJ...
Electronics Forum | Thu Jun 12 15:29:58 EDT 2014 | jimmyboz
Sarge, Red army does not immediately make me want to help, anyway. What is the exact error displayed? There is a chuck open/closed sensor, if not made at the right time it will e-stop with some error that I don't recall. I assume this is on H1.
Electronics Forum | Fri Jun 13 13:19:54 EDT 2014 | cyber_wolf
That little cylinder comes apart. Sometimes they get gummed up and need to be taken apart and cleaned.If it does not make the sensor in time, it pops an error up.
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Fri Aug 01 11:57:56 EDT 2014 | kurtiss
It turns out it was a misaligned fiber sensor on station 12?, the after rotation nozzle verification.
Electronics Forum | Wed Feb 11 11:12:23 EST 2015 | daniel_esposito
Thank you Bobpan! I checked the laser sensor and could see through the glass a small stripe (dash)in the inside lens, just in the middle of it. Thank you again.
Electronics Forum | Wed May 27 10:26:35 EDT 2015 | jodonoghue
hi a long shot but i am looking for help trying to source a cable from a universal rad 5 sequencer . it is the cable that goes between the interupt sensor and the i/o box .. any help would be appreciated or help on where to look thanks in advance
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Thu Aug 13 05:28:45 EDT 2015 | dilogic
We had occasional problems and usually solve it by pulling out pogo pins slightly to extend them a bit... Also note that electric feeders have "reel empty" sensor that gives the same error message (if you are using cut tape strips without reel)