Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Thu May 09 12:06:06 EDT 2013 | pbarton
We run Zipatec 460's also. I presume that you are running Nitrogen? We have found that if the Nitrogen flow rate is too high into the conical nozzle collar it can be sufficient to disrupt the smooth flow of the solder as it runs down the wettable o
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Mon Aug 12 15:56:13 EDT 2013 | pjchonis
Vapor phase soldering systems by Asscon are characterized by special designed heating modules. The thermal mass of the heating modules is designed so that a completely delay-less and direct regulation of the heat/flow/energy transfer to the soldering
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Mon Sep 09 11:18:23 EDT 2013 | shirjer
We have a Vansco system on our 2005 Alpine Coach motor home. We have an intermittent outage problem with the 12V lighter socket. I can plug something in, like the tire sensor monitor, or the GPS, and after I remove it, the outlet no longer works, n
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Fri Jan 30 00:41:04 EST 2015 | neeraj_iiser
Thanks a lot , my application is cryogenic in nature. I am trying to make a Sub-Angstrom resolution Thermal expansion sensor, whose components have been machined out of OHFC copper, and i needed to solder a manganin wire to one of the capcitor plates
Electronics Forum | Tue Mar 17 12:48:41 EDT 2015 | cyber_wolf
Couple things: If the rubber roller that touches the take up wheels is worn you can adjust it. The axle is on an eccentric. Make sure the "teddy bear faces" that adjust the pick point are not grossly different from the left to right sides of the ma
Electronics Forum | Sat Jan 09 13:42:54 EST 2016 | aemery
Bill, Did you ever get this issue resolved? Electrovert is more my cup of tea, but I have completed a couple of pot replacements on the Vitronics waves. I remember on one machine after the retrofit the we were testing the machine and everything dro