Electronics Forum | Mon Feb 24 10:26:50 EST 2014 | rgduval
Jimmy, The higher population board will actually be 7 feeders. Smallest parts are 0805 and SOT-23's. cheers, ..rob
Electronics Forum | Fri Jun 20 07:31:34 EDT 2014 | mdavister
I'm not positive, but it looks like it could be a multilayer chip capacitor with the end metalization on the long side. They do exist: http://www.mouser.com/ProductDetail/AVX/0612YC105KAT2A/?qs=sGAEpiMZZMukHu%252bjC5l7YbS7Gp8EQB5AtLAgTHK6PsA%3d
Electronics Forum | Tue Nov 11 14:33:12 EST 2014 | rangarajd
Hello, I'm currently using the AMS 3.0 Build 30068 software to program my assembleon MG1R and Topaz XII's. The software is currently running on XP and would like to upgrade the OS to win 7 or 8. Is anyone successfully running a newer version of AMS
Electronics Forum | Tue Jan 07 23:38:08 EST 2014 | m_imtiaz
want to know the tolerance the paste height in the solder paste printing. for example if stencil thickness is 7 mil, what will the acceptance level of paste height ( upper and lower) kindly share if any guidelines or formula for the same
Electronics Forum | Fri Apr 18 11:05:47 EDT 2014 | horchak
First things first. Check the manufactures specs on the electrolytic caps as they may not be able to handle the lead free temps.
Electronics Forum | Thu Apr 24 12:18:01 EDT 2014 | cyber_wolf
You must thermally profile your circuit boards with a data-logger and thermocouples. Just putting in oven set points and looking at solder joints is not enough. Reference IPC-7530
Electronics Forum | Fri Oct 03 04:24:54 EDT 2014 | dcarroway
Does any one have a wiring diagram for an electrovert Omni 10. We are having trouble finding why zone 7 runs over temperature.
Electronics Forum | Wed Dec 17 08:47:18 EST 2014 | cloughley
What are the added capabilites going from 7w to 20w, 355nm YAG laser I wanted to know what the added capabilities we now have are going from a 7w to 20w, 355nm YAG laser. Currently we support the following materials: http://www.bestlaser.net/mater
Electronics Forum | Wed Feb 05 22:03:21 EST 2014 | alphatronique
Hi as said clip and and adjustment was not in cause if you look picture part was right at the good place so tape adjustment was good for all the 16 tape and have also replace all the 16 clip whit same result i have service any mydata feeder bef
Electronics Forum | Wed Jul 30 23:40:45 EDT 2014 | matusov
Yes, but I have seen designs where the whole row > of leads has no mask(which is also a NSMD) Apparently I might have to do just that for some parts. We have a few parts with 0.2 mm pads at 0.35 mm pitch. Our PCB shop says that they need at least