Electronics Forum | Mon Sep 09 22:05:51 EDT 2013 | mandysmile
Hello, Do you know the MCPCB electronics and Power separation?
Electronics Forum | Fri Jul 28 02:49:24 EDT 2017 | summertang
PCB Separator assemble manual for you
Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev
Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio
Electronics Forum | Wed Jan 04 10:10:54 EST 2006 | Amol Kane
One of my customer is asking the need for a separate oven for lead-free reflow. In all of my researches in lead-free transition, i have not read anywhere for the necessity of a separate oven for lead-free reflow....am I missing something here?? plea
Electronics Forum | Thu Nov 17 20:23:55 EST 2005 | davef
We're with your customer. We believe inner layer separation is not linked to a heating excursion. What you are seeing is separation between the hole wall and the copper plating in the barrel of the hole on an unstressed PTH. Although, it's possibl
Electronics Forum | Tue Nov 30 12:20:35 EST 1999 | Wolfgang Busko
Hi Steve, is it possible for you to get more than one PCB in a panel and separate them after assembly. Some kind of framepiece for support at the affected edge later to be separated should do it as well. My first ideas Wolfgang
Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.
Electronics Forum | Mon Dec 05 09:31:19 EST 2005 | whippingpost
Not all but some were tested O.K before the failure. What are some of the other reasons for ball separation from the component body besides mechanical stress?
Electronics Forum | Mon Mar 20 00:48:22 EST 2006 | pavel_murtishev
Good morning, In this case separation speed doesn�t affect print quality. Separation speed decrease makes print quality the same or worse. Apertures still remain blocked. Any ideas? Thanks. BR, Pavel
Electronics Forum | Thu Mar 23 10:21:38 EST 2006 | chatech
Recently my company (graphic card suppliers) have experenced some pad to board separation under the processor. I have researched and find that a number of papers have been written about this, but they give no solution, Is anyone out there experencing
.gif)
winsouce.jpg)