Electronics Forum | Thu Mar 24 16:46:29 EDT 2016 | tombstonesmt
The recognition system uses a image histogram for the lead tip check. So, perhaps you were scanning the area from the lead edge to .1-.2 towards the body of your QFP and not fulfilling the required pixel count for that area; increasing it allowed yo
Electronics Forum | Tue Apr 12 21:43:50 EDT 2016 | cmarasigan
There is an auto teach of QFP component for CM402 wherein machine can auto recognize number of pins, pin pitch. Just make sure on your part data you have selected the right reference part (Ref: 171)for QFP. For manual component recog; 1. Set Comp si
Electronics Forum | Sun May 28 23:43:35 EDT 2017 | claire_08
Hi. We provide rework and repair of printed circuit boards to companies all over the world. Key services: BGA Rework Services. BGA Reballing Services. BGA X-Ray Services, Consulting Services. Advanced Technologies R & D Support Services. Hand Sol
Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri Sep 09 06:03:37 EDT 2016 | jswatt
Simple answer is no you cannot do it and why would you?.. is it a cost saving thing? As Dave F correctly points out you have a fair amount of noxious fumes to handle that aren't getting exhausted if you switch of the extraction so they will go to you
Electronics Forum | Tue Jul 12 08:54:34 EDT 2016 | leeg
well there you go. I found that trying > different values in the "Placing Stroke" had a > big effect. I changed it to 2mm and it placed > them well, but I could see the board also flexing > a little, went to 1mm and the problem came back, > so
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.