Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Sat Mar 28 17:38:14 EDT 2009 | Peter
Hi, I bought a Philips CSM84 machine 2 weeks ago. I have no experience on SMT machine so I try to learn everything from the manual. There is an error message when I program a simple program and try to get it executed. "PCB FIXING ERR. LOCATE PIN NO
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware
Electronics Forum | Fri Jun 26 09:09:17 EDT 2009 | boloxis
thanks James, that is good to know about Assembleon. Siemens does that all the time to me nowadays. Anything that anybody want to say to Universal Advantas X ? I benchmarked a Universal AC30 + AX11, an Assembleon MC24 + MC1, a Siemens SX2 + SX1, a Ju
Electronics Forum | Tue May 26 11:13:49 EDT 2009 | xinxi
Is the components on the top or on the bottom of the pcb? Have you checked whether the temperature on pcb are too high when it pass through SW that it exceeds the limit that the components can take? Do check with the component manufacture for the te
Electronics Forum | Tue Jul 07 12:50:33 EDT 2009 | davef
First, we don't know dip about nonbalanced squeegee. We clipped the above gif from: Solder Paste Printing Inspection: An Inside Look; E Litman, System Engineer, Orbotech; SMT January, 2004 Second, Tekscan talks about a product: I-Scan force and pre
Electronics Forum | Wed Jul 29 07:26:12 EDT 2009 | dilogic
Hi Patrick, thanks for the response. I might add some more information - we succesfully soldered some boards with the same settings of belt speed, pre-heat temp. etc. This batch of boards differs from the previous in a way that they are 4-layer. May
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Wed Sep 23 03:43:31 EDT 2009 | d0min0
hello, we are profiling with the pcb each day - results are very good with a small delta we made another test board with TC only in the problem places - same good result we tried 500-600 boards on 12 zone machine - zero defects while on standard 6
Electronics Forum | Fri Sep 04 02:09:03 EDT 2009 | sachu_70
Hi Walter, Do you refer to a sprayfluxer operation? The problem seems to be a parameter setting issue. 1. Ensure the wide angle spray reaches PCB with optimum jet pressure. You could pass a glass plate to understand flux coverage and view Jet pressur