Electronics Forum | Thu May 11 15:07:42 EDT 2000 | Finepitch Services
I assume your oven has a "board width" setting for every board and the conveyor width is automatically adjusted as soon as you select the profile/recipe... For the double sided reflow boards, I would set the width 1 inch (or another rounded amount)
Electronics Forum | Wed Apr 26 17:33:24 EDT 2000 | John
I agree with what has been said, P pattern takes some playing with, but length and width need to be what the machine is seeing not actual (use trace). The biggest improvement I got was slowing the frontlight scan speed to 50% of backlight setting in
Electronics Forum | Wed Apr 19 18:02:34 EDT 2000 | Mike Flori
If you can divide your boards into different categories it allows you to determine a different starting profile for each category, based on size, # of layers, etc. When you get a new board to profile you'll have an idea what settings will get you clo
Electronics Forum | Fri Mar 24 15:20:27 EST 2000 | Chris McDonald
I have recently purchased a Tape and reel machine from V-Tech. We are using Presure Sensitive tape and we are not geting good results. Anything bigger that a SOIC14/16 gives us trouble. The cover tape will pull off on the feeder and we will lose part
Electronics Forum | Fri Jan 26 08:28:59 EST 2001 | Sal
I am currently in the Process of setting up some SPC software on our Wavesoldering equipment. What I would like to know for each Parameter that is listed below what kind of variation from my average setpoint would cause defects.Example. If the averag
Electronics Forum | Wed Mar 28 00:20:48 EST 2001 | chinaren
we use the screen glue AMICON D125 F5 from Emerson company of Belgium and stencil is Varidot stencil from Loctite with thickness of 250 micrometers The squeegee is also from loctite, previously we use squeegee of material PU, it is easy to be broke
Electronics Forum | Mon Jun 18 18:14:59 EDT 2001 | davef
Would comment extensively on the following? The time is a fact for X-ray inspection. If you set the contrast, tilting angle correctly (provide you did enough cross section to know the few type of failure mode: e.g. smaller balls, shorts, missing on
Electronics Forum | Thu Jan 27 20:36:13 EST 2000 | Dave F
HJ: Your best chance of running your boards with a single profile is with ovens from the established suppliers (ie, BTU, Conceptronics, Heller, Vitronics, etc). They are experienced in robust control system designs. Stepping aside from that, consi
Electronics Forum | Sat Jan 15 13:13:33 EST 2000 | Mark Wiegold
Steve, Basically in answer to your question, there is no real set number for defects. Defect rates will vary between products and companies. If my company was running the same product as yourself then there is no reason to suggest that the defect ra
Electronics Forum | Tue Dec 21 13:27:47 EST 1999 | Vince Whipple
Charlie: As far as setting up a spray fluxer.. Are you spraying no-clean, voc free, water soluble? What you would want to do is to run a blank pcb through the fluxer and pop it out before the preheaters. Visually inspect for variations in uniformit