Electronics Forum: setting (Page 1 of 454)

BTU oven air setting

Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi

We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay

SIPLACE repick setting

Electronics Forum | Thu Oct 06 06:31:45 EDT 2022 | hta1979

Hi all ! We changed the repick setting of a part in Siplace Pro. But when we sent it to the machine, the setting did not change. My question is,it possible that this option only works with the 505 station software? This is an F5HM,we have 406 softwa

SIPLACE repick setting

Electronics Forum | Thu Oct 27 20:32:43 EDT 2022 | oxygensmd

Hello. - Pickup offset works on with or above 505 softwares. - Offset correction works on feeders but the ProDesk won't overwrite your current SetUp / feeder cart. You have to overwrite manually or make new SetUp in Job (using optimalization),

Reflow temperature setting

Electronics Forum | Thu Jun 08 01:52:16 EDT 2006 | ec

Hi, Is there any special temperature setting for example , bottom temp should be lower than top temp to prevent component drop. Or any information that can help to prevent component from drop off during reflow of top side.

Reflow temperature setting

Electronics Forum | Thu Jun 08 03:40:32 EDT 2006 | aj

Hi, I use convection reflow and both top & bottom settings are the same. Is the part too heavy to rely on surface tension? there is an equation that can determine this (aswell as real test i.e. part falling off) We have some SIM Card holders on bot

Reflow temperature setting

Electronics Forum | Thu Jun 08 17:21:31 EDT 2006 | PWH

EC - I hope you don't mind that I add to your question... We are running lead free assemblies now and parts that normally hang on upside down are falling off. Any advice on this from others new to lead free?

Reflow temperature setting

Electronics Forum | Fri Jun 09 04:21:20 EDT 2006 | rlackey

Hi EC, there was an in depth post dealing with this back in 2000 from the now legendary Bob Willis: http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=1468&#Message6342 Cheers, Rob.

SIPLACE repick setting

Electronics Forum | Mon Oct 24 13:17:18 EDT 2022 | micropak

I have successfully used "Offset" in pick position on a particular feeder/component on F3. My L/C is Linux 503.04 and SC software is probably 010 (RMOS). This 406, you are mentioning as Station software ? I believe you have to do it in feeder setup,

Reflow temperature setting

Electronics Forum | Thu Jun 08 04:31:24 EDT 2006 | vasily

Hi First I think you have to analize your PCB design. Heavy weight components should be gathered on one side of PCB. As I think, if you want to reflow both sides simultaneously there might be a problem. A chance that large components will drop off

ap25 hi E solvent menu setting

Electronics Forum | Tue Dec 18 11:57:05 EST 2007 | kingfish

I have an AP25 HiE which I am going to use solvent on a perticular job. What are the best settings for the solvent menu?

  1 2 3 4 5 6 7 8 9 10 Next

setting searches for Companies, Equipment, Machines, Suppliers & Information