Electronics Forum | Wed Apr 27 13:49:11 EDT 2005 | Shean Dalton
Hi Sarag, We share Sara's described experience with cleaning No-Clean/Low Residue flux residues. We can add that of the Low Residue residues, Indium SMQ92J is one of the more challenging flux residues to clean. That said, we have had repeated succ
Electronics Forum | Wed May 04 08:41:01 EDT 2005 | Hannu
OK, granted, this is not exactly your hi-tech SMD production but pertains to lead-free so I'll post this anyway: Can anybody share their experiences on lead-free dip soldering of transformer terminals? I have not done any testing myself but have see
Electronics Forum | Thu May 12 15:35:16 EDT 2005 | msivigny
Hi Sam, I'm afraid I can't answer this question in this forum. I'm sure many people would like to know which model or brand is better than the next, but even if we had the data, we would not share it. Our independent measurement services and associat
Electronics Forum | Fri May 27 02:36:27 EDT 2005 | Base
Hi John, What type of machines are you using? (for all you vendor-bashing badmouths out there: this is not an invitation to start advertising you personal favourites!) There may be people out there that have done this trick before on exactly the s
Electronics Forum | Mon May 30 14:03:59 EDT 2005 | MikeaJ
Harry may absolutely be on to something. Although you may have multiple issues, the minute Harry mentioned "transformer", a big bell went off in my head. A retrofit was released a number of years ago to address it. I actually put a few of these in ov
Electronics Forum | Fri Jun 24 13:56:05 EDT 2005 | John S
This is a little late, so I hope you've been in contact with E-vert. We've experienced the same thing on our two vectra's. It normally happens right after a bad electrical storm. The shared drive will have to be reprogrammed. E-vert can fax you a
Electronics Forum | Tue Jul 12 04:21:29 EDT 2005 | Chris Ong
Hi, Have anyone out there been using Asahi products. My knowledge is limited and I only know it from the http://www.asahisolder.com website. Pls feedback or share your view on the Asahi product. If this product worked better than other even if it h
Electronics Forum | Tue Jul 26 23:02:22 EDT 2005 | crishan
Hello, We currently have huge quality issues with our Inertec selective solder machine, the model we have does not pump solder, rather the solder bath is raised to the product. We have continuing issues with bridging and non wetting of joints. We a
Electronics Forum | Mon Sep 19 09:02:10 EDT 2005 | clampron
Good Morning Everyone, We have a customer that produces RF based assemblies. We are building several board types for them, all of which have an "RF" area of the PCB. This RF area does not have any mask to define pads. There are also several issues w
Electronics Forum | Tue Sep 20 23:12:38 EDT 2005 | darby
Several suggestions. Your hands may be tied but here goes. 1. Doctor your stencil so that pads are not shared etc and reduce the apertures more that what you would normally. This may stop one pad wetting into another etc. 2. The use of a Pb-free sol