Electronics Forum | Wed Nov 18 05:21:18 EST 1998 | jack coia
Please could anyone give me any relative information concerning shear tests on the leads of SMD ICs. thanks in advance.
Electronics Forum | Mon May 22 10:41:50 EDT 2000 | Scott G
Can anybody provide information on shear testing of passive components. What standards are used etc. Thanks
Electronics Forum | Mon Jul 24 23:34:14 EDT 2000 | rzkr438
I am tyring to find out shear force requirement for BGA attached on board .I measured two group for shear force to check underfill process effectiveness on BGA .Two group showed siginificant force diferrence .I am very sure underfill process is effec
Electronics Forum | Wed Jul 03 03:02:35 EDT 2013 | autoel
How to test the reflow solder joint shear strength? What are the specification to test solder joint shear strength? What are the different methods to test the solder joint shear strength? Vijayashree
Electronics Forum | Wed Jul 03 15:40:17 EDT 2013 | davef
Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied than on the grain structure. When shearing a component, you not only apply shear stress, but also roll
Electronics Forum | Fri May 17 16:37:28 EDT 2002 | Tom Druan
I was wondering if anyone could direct me towards documentation on shear test methods/apparatus to test the bond integrity of a solder ball to its substrate. Thanks.
Electronics Forum | Fri May 17 16:53:50 EDT 2002 | davef
I recall a couple of papers in the SMTA 'Knowledgebase' that used ball shearing and an element in a study that compared BGA [maybe uBGA] component fabrication methods, er sumpin.
Electronics Forum | Tue May 23 20:39:37 EDT 2000 | Dave F
Scott: Sounds like fun: � Solder joint strength in pull/shear varies with lead geometry, solder volume, lead metal/metallization, and the test method. � Among things, IPC-TM-650 talks to getting pads off-of boards. For instance: Method 2.4.8 is for
Electronics Forum | Fri Mar 30 18:24:12 EST 2001 | davef
There is no test. Beyond the issues that you mentioned that affect shear, an article published in a recent [1/01] "Journal Of Surface Mount Technology" documents that shear is also dependent on the rate of shear. You may be able to contact the auth
Electronics Forum | Sat Mar 31 08:47:24 EST 2001 | davef
Sure, researchers measure shear as an element of their material characterization process, but that does not make it an acceptance test. [Truly, this conversation is not uncommon on SMTnet. So, it would not surprise me if an enterprising something o
