Electronics Forum | Tue Mar 09 20:08:08 EST 2004 | davef
Warping BGA are the usual cause of shorts in the corners and are usually caused by the reflow profile. BGA have a natural tendency to warp due to CTE and package thermal mismatch, as you have seen at rework. The PBGA will go from a bowl shape to an
Electronics Forum | Tue Mar 30 20:04:19 EST 2004 | Ken
If speed is truly an issue, migrate to no-clean. However, this is not always an option. Why bake after 1st smt pass? Because you are probably not drying completely under the BGA components, and/or you are pushing water into the parts/boards/ vias
Electronics Forum | Sat Apr 03 16:39:15 EST 2004 | stefwitt
We had a similar system on the Siemens machines, quite some time ago. However, it was not a laser light but a LED and a fiber cable. Actually the center fiber or receiver was surrounded by a bundle of small fibers for the LED light source. You may al
Electronics Forum | Sun Apr 04 10:16:16 EDT 2004 | cyclopsn
I'm involved in backplane manufacturing process. There are about 10 electrolitic capacitor assembled in my board.These capacitor are soldered using a selective soldering machine. My problem is that these capacitor will charged up and failed as short
Electronics Forum | Mon Apr 12 09:09:25 EDT 2004 | russ
If they are reflowing pbfree balls to bare PCB pads they are getting that component very hot tpo melt the balls and get them to wet to the pads! I would not recommend this process at all for hightemp solder balls, for 63/37 this process is fine. As
Electronics Forum | Wed Apr 14 05:44:36 EDT 2004 | hun
Hi All, Just have a share with you guy. We are using T4 solder paste and also E-Stencil. We ahd try out Alpha, Kester, AIM and Qualitek. The result show Alpha had a very very heavy stack flux and can't get it clean off even by chemical
Electronics Forum | Wed Jul 14 17:33:04 EDT 2004 | Ross Clunie
The short answer is "No" the white and green feeders are not interchangble. The green feeder has a channel in it to allow the "embosed" or plastic tape to fit flat at the pickup position. If you use paper tape in this type of feeder the tape can be d
Electronics Forum | Sat Sep 25 08:59:59 EDT 2004 | davef
IPC-HDBK-830, Guidelines for Design, Selection and Application of Conformal Coatings says: A conformal coating may have several functions depending on the type of application. The most common are: * Inhibit current leakage and short circuit due to h
Electronics Forum | Thu Sep 23 10:48:21 EDT 2004 | Mke
Hi, My experience in the past has been predominantly with Fuji, Universal and Siemens. I categorise each of these systems in different ways; 1) If I want bombproof reliability - I Choose fuji. There tough mechanical design ensures operation time
Electronics Forum | Fri Oct 01 04:31:08 EDT 2004 | pioneertechnology
Hi Marcel I bought four BTU ovens a couple of years ago at auction and had the same problem where two of the ovens had software and two did not. I loaded in the software I had onto the two ovens and this only partially worked as the software is con