Electronics Forum | Thu Feb 21 12:02:03 EST 2013 | pbarton
We agree with all of what Patrick has said. Hopefully your equipment is capable of the ideal setup you describe with no back flow until the product hits the wave and then back flow until the product emerges the other side. One other reason to strive
Electronics Forum | Mon Jul 01 13:25:31 EDT 2013 | tpost
I think it is wetted also but I cannot verifiy without actually seeing the toe, heel or side fillets. In this case, the lead was overhanging the pad and as with this type of lead it is not acceptable so they were reworked. Many times rework personel
Electronics Forum | Tue Aug 13 10:22:13 EDT 2013 | mccabekev
We are seeing this the full length of the oven. We run a lot of double sided boards, so we cannot run them on the wire mesh. I checked inside the oven to ensure there was no build up of dropped parts that could block it. The temperature difference
Electronics Forum | Fri Aug 30 10:19:09 EDT 2013 | proceng1
http://i73.photobucket.com/albums/i236/djturnz/IMG_20130830_100237_874-1.jpg It is an IR receiver. Our customer does not know the manufacturer from an old assembly of theirs, but they'd like us to start building them. This is one of the parts we are
Electronics Forum | Fri Sep 06 12:34:00 EDT 2013 | bobpan
Your firmware is so old that the problem is not in the mod codes anyways. You have a problem with the cyberoptics head. If its not working at all, i would remove the lens assy on the front side where the cable plugs in and blow out the unit. Maybe if
Electronics Forum | Tue Oct 08 11:20:37 EDT 2013 | markhoch
I'm looking for evidence to support, or disprove, the use of Nitrogen in the reflow oven. I've heard many arguments on both sides. I have my own personal opinion. But I'm looking for scientific studies or white papers, specifically addressing the ben
Electronics Forum | Fri Oct 18 08:54:18 EDT 2013 | emeto
Hege, the Nano coating goes on the opposite of the squeegee side of the stencil. I don't know if the cleaning paper is able to remove it little by little with the time, but I never refreshed my stencils with Nano coating and they work just fine. How
Electronics Forum | Sun Nov 10 09:58:38 EST 2013 | kumuda
We have been using a circuit board in the assembly of HV Tank used in X-ray generator. This board acts as a sealant to the oil tank opening. The top side area of the board which comes in contact with oil is conformal coated to avoid oil leak. However
Electronics Forum | Tue Nov 26 13:56:09 EST 2013 | aaronpavone
If I wanted to verify my process to ensure that it is not exceeding maximum lead temperature for the determined time on a component data sheet while soldering, where should i measure from? I am currently measuring from the tip of the lead on the seco
Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo