Electronics Forum | Sat Nov 04 07:10:48 EST 2006 | tony_d
Hello bpeach, I recently purchased AOI system for our company. We are a low to mid range manufacturer as well. I looked at several different vendors around the price range that you are looking at incuding; Mirtech, Viscom, N-Spec, Omron, VI Tech, Or
Electronics Forum | Sun Nov 12 01:02:58 EST 2006 | Thomas
One printer 2 smt lines = No problem, but then you will need 2 ovens. It is even sometimes a more valuable cost savings depending on what production you are into. At first the stencil printer with a divertion conveyor, then straight ahead into the 1
Electronics Forum | Tue Nov 14 18:38:59 EST 2006 | Brandon
Hello all, I am having an issue with some boards on our Wave Solder. It is a Pb free wave and These particular boards are exibiting A LOT of what I call solder bubbles in the larger than usual vias and un-used thru holes. Settings: 4 inch/min 144c to
Electronics Forum | Wed Dec 06 11:16:06 EST 2006 | Todd
Ok, an update... I finally found my 24Vdc. I was trying to use a screw and/or outside of the connector for ground. It was necessary to use the ground IN the connector pins. I believe it was the top/right and 3 o'clock pins that toggled with the 24Vdc
Electronics Forum | Mon Dec 11 05:30:11 EST 2006 | mika
[Drop down menus] > Machine > Configuration > Parameters > Axes => You are now on a page with 3 menus > on the left side menu [Axis choice] scroll down and mark [Transfer belts] > On the upper right menu [Configurable Values] > mark [Default maximum
Electronics Forum | Fri Dec 08 19:09:44 EST 2006 | darby
I have just started production run using this component. After reflow I see that there is an undercut of solder between the pcb and the lead instead of a fillet. This means that some of the leads are sitting above the solder with no wetting to the co
Electronics Forum | Wed Jan 03 19:12:09 EST 2007 | Mike F
If I could set it up for markers and leave it I probably would not be as frustrated with the printer. We also run polyimide labels through that same printer, which means you have to adjust that sensor to a different position. Then when we switch back
Electronics Forum | Fri Dec 29 08:14:19 EST 2006 | joey_dragon
Thank you for the quick reply! Actually, the "type B" I referred to applies to a flex cable that can be found in this page: http://www.tennrich.com/trtw/cabling_3.php It is a reverse Engineering project and, from what I can see, there is, indeed,
Electronics Forum | Fri Jan 05 10:15:55 EST 2007 | Cmiller
I have a customer working on a new design of a rather large board that needs to use a micro BGA that will require 8 layers. He needs to use that BGA and it does not come in any other package. He asked me about making the BGA an adapter or daughter bo
Electronics Forum | Mon Jan 15 06:18:50 EST 2007 | CL
Good Morning Stephen, 1) Most solder paste manufacturers recommend a 2 hour temperature stabilazation period. Solder paste should not be opened and exposed to ambient air if it is still cold. 2)Manufacturers do not reccomend mixing old and new paste