Electronics Forum | Thu Jan 07 03:34:24 EST 2021 | ravikumargv
Attached Image FYR....
Electronics Forum | Sat Nov 28 09:49:58 EST 2020 | ravikumargv
Dear all, kindly help me to solve above issues... regards, Ragav.....
Electronics Forum | Thu Dec 03 13:56:58 EST 2020 | emeto
Looks like a communication issue to me. IP addresses are wrong or cable/network card is not working
Electronics Forum | Thu Dec 03 14:52:07 EST 2020 | SMTA-64304333
did you confif the ip/host ad MC ? using the ifconfig command?
Electronics Forum | Thu Dec 03 17:56:59 EST 2020 | ravikumargv
Hi, Ip and mc host both pinging and no issues, but still sitest given communication error, for this i replaced communication card and lan cable as well. But machine software not booting at all... Regards, Ragav
Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Sat Jan 09 20:00:04 EST 2021 | oxygensmd
I had similar issue on S20 two times. The portal2/gantry2 have camera image? Have working camera system - if other camera ok, PCB camera will be the problem. Have camera screen on BE/Components camera? Have iCOS PC working. - Check the camera conn
Electronics Forum | Thu Nov 26 03:59:59 EST 2020 | ravikumargv
Dear All... Greetings.... Recently My S27HM machine MC had problem and i replaced another same S27HM machine MC and updated BIOS and installed RMOS1&2 after Distribution successfully completed power off the machine and power On the machine, afte
Electronics Forum | Mon Nov 27 16:31:07 EST 2000 | Chris Jackson
I am evaluating several pieces of Siemens equipment and would like to get some input from industry users. I am seeing that Siemens is able to meet cycle time estimates and thus throughput. I am concerned about the robustness?? Any input is welcome. T
Electronics Forum | Tue Nov 28 16:28:14 EST 2000 | CAL
Chris- The machines you identified are stable products and have been around for over two years now and most bugs have been worked out. The F5 IC head has not changed much since its introduction over 5 years ago. Remember these machine like to run, r
