Electronics Forum | Thu Feb 13 10:56:14 EST 2003 | cbarnett
I have always foound that the actual cycle time is much better than the simulator.
Electronics Forum | Fri Feb 07 11:03:35 EST 2003 | amair
Hi, Anyone can tell how accurate the gsm performance simulator if compare to actual production cycle time?Sometimes I found the cycle time for production run is much better than the simulator.
Electronics Forum | Wed Feb 19 15:36:14 EST 2003 | Jaime
The GSM simulator is good for estimating how long it will take,just to give you a ball park figure. That is my opinion. We do use GSM's, and I do use the simulator for HSP and GSM to balance the line. It's a good start point.
Electronics Forum | Tue Mar 25 08:36:41 EST 2003 | Benny
How can i simulate vhdl code or graph in analog circuit simulator?
Electronics Forum | Thu Nov 07 01:47:37 EST 2002 | Bach Huss
Hi all, I plan to measure the placement repeatability and accuracy. Is there any work done to simulate the paste effects on test board without using paste (My measurement equipment is a back lighting equipment). I saw someone placing components on
Electronics Forum | Sun Oct 07 03:46:20 EDT 2012 | ekki511
Hi Jeff we opend the HHK and removed the Eprom . We reed out and put it back. After that I dont know why it worked . By the way: we have a simulation program for our Saphire where we can prepare programs . Did you ever heared of a simulator for the
Electronics Forum | Tue Mar 30 09:23:16 EST 1999 | Lars Jaeger
Hello, I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. My problem is how to assign the correct feeder width to various devices in a simulation. Is
Electronics Forum | Thu Nov 07 06:10:13 EST 2002 | stefwitt
I used once flux cream on a glass plate for a customer application, which should simulate almost the same cohesion than solder paste.
Electronics Forum | Wed Jan 12 11:54:13 EST 2000 | Chen Zhou
Vishy, We have a project to study the impact of productivity lift in SMT lines using discrete event simulation tools (AutoMod is what we use). As Mr. Lahat found out, the high fidelity simulation of productivity lift is non-trivial. However, we have
Electronics Forum | Mon Aug 26 00:17:32 EDT 2013 | alexeis
Hi, After you got datasheets of component shapes (only new one) and enter it to SMT machine library (including Polarity Mark and Position), you can use our software to simulate and fix all angles. Also, our software has tools to add Polarity informa
.gif)
