Electronics Forum | Tue Jun 06 11:57:12 EDT 2006 | Chunks
IPC 610 says acceptable Class 1 (Class 2, 3 indicator) if they are entrapped/encpsulated balls within 0.13mm of lands or pads. or exceed 0.13mm in diameter. Defect Class 1,2,3: Solder ball violates min electrical clearance. Solder balls not entrap
Electronics Forum | Tue Jun 06 15:45:18 EDT 2006 | slthomas
Yep. What I'm really looking for is the minimum radius of curvature for 63/37, which is a function of it's surface tension. It's physical properties issue, not an agency issue. I've seen some references that I have interpreted to mean that it's some
Electronics Forum | Wed Sep 07 00:28:04 EDT 2011 | woodsmt
I have identified a Board design issue and having trouble convincing others of my findings. I have a BGA (Sn63 balls, +1500 IO, 0.6mm ball, 1mm pitch, with heat spreader plate)that has a high incidence of solder shorting on the corners. The board i
Electronics Forum | Fri Jun 30 10:42:24 EDT 2000 | Chrys Shea
That pad had a 16 mil dia, so I arrived at 20 mil squares by adding 2 mils to each side of the pad. Following that logic, a 12 mil pad would use a 16 mil square. But a 12 mil pad is on a finer pitch that isn't mentioned, so you should definitely
Electronics Forum | Mon Jun 07 17:58:12 EDT 2004 | Rob
UPDATE: Just for fun... I sacrificed a scrapped board to determine what remained and what fell and this is the result. Board dimension was 18"x9" and .9" thick. Components consist of hundreds of passives plus 386 proc (QFP256), TSOPs, SOLs 14/16/20,
Electronics Forum | Thu Apr 02 21:25:16 EDT 2009 | davef
On Orbel E-Z SHIELD, Surface mount two-piece fence and cover: Make the pads 1:1 with the pads on the fence. On Autosplice MINI 7-V2004-115 RFI Clip floating: * Autosplice recommended pad small dimension is very close to the small dimension of the pa
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Wed Jun 07 10:56:38 EDT 2006 | Chunks
In the past, I would normally tell out highly talented inspectors to leave the balls there. The were trapped in the flux residue and were hard to remove. Never caused a problem. But then there was an incident where someone had the bright idea to u
Electronics Forum | Wed May 12 20:32:14 EDT 1999 | Earl Moon
| Earl | | you posted a message on 1-14-99 about converting to VOC free flux. Have you completed your evaluation? Could I get a copy of any data supporting your conversion to VOC free? | | Thanks | | WDR | | WDR, We are awaiting the latest dat
Electronics Forum | Thu Oct 23 18:39:41 EDT 2008 | kiter
Was wondering if anyone has a general chart matching SMT package size with tape feeder size. E.g 0602: 8mm Tape 2mm pitch. Cheers.
.gif)
