Electronics Forum | Fri May 06 08:47:05 EDT 2016 | davef
You're correct. This design will have a record amount of 0402 rework for tombstoning and misalignments. Suggest that the pads on each end of all components be the same size in order to balance wetting forces during reflow.
Electronics Forum | Wed Jul 13 11:57:08 EDT 2016 | ahernand75
Guys I'm looking for a software on the web that I can use to do void measurements. I have x-ray images but unfortunately no software in the machine to be able to calculate void size. Thanks in advance for your support.
Electronics Forum | Mon Jan 30 19:20:45 EST 2017 | jgo
Thanks Rob. I'm not so sure in a mass production environment that using the mount spray and kapton tapes are going to be efficient. For solder paste dispensing, any idea what is the smallest solder dot size the machine can dispense?
Electronics Forum | Mon Feb 06 16:15:08 EST 2017 | ttheis
Great, that is encouraging. I did order a few needle sizes from McMaster to try out when we get the machine setup. What do you recommend for clean up the equipment?
Electronics Forum | Fri Feb 03 11:47:29 EST 2017 | lleonard
Is this for a Selective Solder? If so what size nozzle do you run. I run at 315 C most of the time. You can speed up your process time and still achieve good solder fill.
Electronics Forum | Fri Feb 03 17:57:40 EST 2017 | sarason
Is it the weight of the component versus nozzle size and vacuum pressure? sarason
Electronics Forum | Mon Feb 06 07:20:12 EST 2017 | prdmm1
2010 component. and the vacuum pressure is good. using an A14 size tool. tried a smaller tool as well. wondering if it could be the coating the company uses to make the print on the part. maybe its not even or something?
Electronics Forum | Wed Apr 26 22:59:46 EDT 2017 | navworx
Great posting. We're looking at AOI for the first time and are trying to understand the pros/cons of 2D, 2D+, and 3D. M, can you discuss what size parts are too small for the Mirtec MV-3L?
Electronics Forum | Tue May 23 03:43:22 EDT 2017 | zsoden
Oh wow that is very useful insight! I will remove and check next time we fire up the machine! How did you know the factory size of the intake hole?
Electronics Forum | Thu May 31 23:29:57 EDT 2018 | judy49
Hi dear We are the manufacture for the smt stencil roll wiper for the DEK .EKRA MPM ect printer machine .any size can be customized . Hope we can have a chance to support u .