Electronics Forum | Wed Jan 03 15:11:09 EST 2007 | kennyg
Is it acceptable to apply an acrylic conformal coat, cure and then apply a silicone RTV on top (for staking tall components)? Should there be a concern with the bond between the acrylic and the RTV?
Electronics Forum | Mon Dec 22 20:16:17 EST 2008 | davef
The first question in solving the "ol' SMT component loss after second-side wave operation" problem is: So, what makes you think the components actually came-off in the wave and not during some previous 'handling'? Putting that aside, we'll play thi
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Thu Feb 12 22:21:08 EST 2015 | shahrat
So what problems you are facing with Mirtec? Can u check coplanarity, less solder, polarity, dry solder,Pads not properly got the heat for 1005 package. Can u also check 0105 components that is surrounded by some tall components? what about false cal
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
| 1 |
