Electronics Forum | Tue Dec 06 08:35:17 EST 2005 | geb
Hi, I have put a new camera into a Universal GSM(1) machine, but it takes up an extra feeder slot either side. When optimising itself it does not know that a feeder won't fit there. Does anyone know how to tell it not to allow feeders in certain slot
Electronics Forum | Tue Dec 20 08:26:17 EST 2005 | geb
Thanks for the info. Yes the old camera was a 4mil rectangle, and the new one is a 1mil circle, 2 slots wider. The camera was calibrated on install, but they must have done something wrong, cos it doesn't realise it is 2 slots short. This screws up t
Electronics Forum | Sun Dec 25 17:35:06 EST 2005 | Mika
No camera re-calibration is required. Just don't load the deafult calibration parameters. /
Electronics Forum | Tue Dec 06 14:56:46 EST 2005 | bigdaddysoy9
Did you update the configuration for the new camera? After changing the configuration I think you have to power cycle the machine for the new settings to take effect.
Electronics Forum | Tue Dec 06 15:19:17 EST 2005 | geb
The install was done by an engineer who does not work for us anymore, so I don't know what was done, the camera operates fine though. Can the size of it be re-configured without re-calibration? Could you tell me the menus to use.
Electronics Forum | Wed Dec 07 17:47:26 EST 2005 | bigdaddysoy9
Machine->Configuration then click on the camera graphic and a configuration screen for that camera will pop up. Verify that your configuration matches the camera you have physically mounted on the machine.
Electronics Forum | Thu Jan 05 19:01:52 EST 2006 | mika
Hi, How dit it work out for You? Just curious. We all of us can benefit from Your experience. /Sincerly
Electronics Forum | Tue Dec 20 16:47:22 EST 2005 | toml
Parameters -> Cameras) Look at the camera serial tag and you should see C4 or OAL or C4 OAL. Make sure the camera type is set to strobed RS170 (C4) or whatever type you have. Then set defaults for this camera, and power cycle. This will fix the f
Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Thu Sep 14 11:15:15 EDT 2000 | Graeme
I also have and run a FGL1 I checked the rack in our machine and there are nine slots numbered left to right slot 1 VM1110TA,slots 2,3,and 4 none slot 5 VM1520, slot 6 VM1510, slot 7 VM1530, slots 8 and 9 none.Have you tried Astro Technology ltd Tel
.gif)
