Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Tue Jan 31 03:34:50 EST 2006 | chadnugent79
If you are sure that your part data is correct, have you checked the calibration of Z origin? Are the parts leaving an impression on the paste or is there no indication of an attempted place. How small of resistors are we talking 0402, 0603, 0805?
Electronics Forum | Fri Jan 27 20:10:16 EST 2006 | peter
hi guys the scenario is: when placing parts which required maximum speed, the cp6 sometimes missing resistors here and there, when checking part data, everything ok i notice that when the machine switching between high and low transport speed, (eg: r
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Mon Jan 30 13:26:12 EST 2006 | Tech
Another thing to keep in mind are the vacuum hoses. The early models had a real problem with the vacuum hoses that connect to the back of the windmill. They would crack or wear through due to rubbing and cause a loss of vacuum which could cause your
Electronics Forum | Fri Dec 10 06:06:54 EST 1999 | Wolfgang Busko
Hi Glen, looks like flux or solder mask problem. In your first mail you said that only some boards show these symptoms and others not. First I would check on the differences between those Boards, manufactorer, solder resist, contamination. If that d
Electronics Forum | Wed Nov 24 13:42:41 EST 2004 | Frank Jachetta
Could you tell me what parts you used for the filter etc. This sounds like exactly what I need. Thank you, Frank Jachetta Multidyne
Electronics Forum | Wed Jul 18 00:37:19 EDT 2012 | stgeorgeau
Hi....The key to good auto repair lies in troubleshooting the problem. If your car won't start, there are a number of things that could be causing the problem. Proper troubleshooting by electrical contractors will eliminate potential issues that ar
Electronics Forum | Thu Oct 30 05:05:08 EDT 2008 | allgood
I havent used it yet but I do find myself keep coming back to it - I have been searching for a decent ERP system for my micro company for years. What I like about it is the way you can export and import just about any data which we need to do as our
Electronics Forum | Thu Oct 30 14:46:33 EDT 2008 | rgduval
I've used DBA in the past. It's not a bad MRP software for the price. Though, your mileage may vary. We were using an older version of it at my last company, and there was no desire to upgrade. From a manufacturing standpoint (bill of material co